Hiker H-901 Anweisungen - Seite 2
Blättern Sie online oder laden Sie pdf Anweisungen für Elektrowerkzeug Hiker H-901 herunter. Hiker H-901 2 Seiten. Grommeting hand press
Seite druckenQUICK REFERENCE GUIDE
Clip holds handle upright
between insertions
Keep shaft clean and
occasionally lubricate
* Spring loaded pin on top
die holds grommet
* Bottom die holds washer
Carriage bolts secure
press to base
Base keeps
press portable
and stable
Put washers on carriage
bolts and tighten
If the die setting is too tight (the bottom die is up too
high), excess force will be exerted on the press when
Material
the handle is pushed all the way down. This will make
inserting grommets more difficult and could damage or
break the press. Adjust die to provide sufficient room
for the material thickness to be grommeted.
* Die Sold Separately
Hex bolt holds top die in place
Dial raises die up
or down for thin
or thick material
Screw & nut prevent die
sleeve from spinning
when adjusting
bottom die
Screw, wing-nut and washer secure die in place.
Loosen wing-nut before adjusting die. Tighten
wing-nut when desired setting is obtained.
CAUTION
GROMMETING SEQUENCE
Material
1) Adjust die to approximate
thickness of material to be
grommeted
Bolt keeps handle
at peak power.
Do not adjust.
Adjust bottom
die only.
3) Place material between die and press
handle all the way down
STEP-BY-STEP ADJUSTMENTS & TIPS
Raising or lowering the bottom die to adjust for various material thicknesses:
1) Close the die by lowering the handle. The distance between the die when closed
should be slightly larger than the thickness of the material you will be inserting
the grommet in.
2) If the gap needs to be more or less, loosen the wing-nut that is underneath the
base, directly below the bottom die and turn the metal nut (like a dial) that is at
the base of where the bottom die sits.
2) Place grommet on spring loaded pin
of top die and washer on bottom die
4) Finished