Jacuzzi SHER120 Benutzerhandbuch und Installationshandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch und Installationshandbuch für Schwimmbad-Filter Jacuzzi SHER120 herunter. Jacuzzi SHER120 6 Seiten. Sherlock element pool filter
Auch für Jacuzzi SHER120: Benutzerhandbuch und Installationshandbuch (4 seiten), Benutzerhandbuch und Installationshandbuch (4 seiten)
Seite drucken
Note: The element support assembly on the Sherlok auto-
matically purges any accumulated air to maintain the internal
water level up to the top of the cartridge. We, however, recom-
mend periodic manual opening of the vent plug to purge any
small amounts of air accumulated under the cover.
REMOVING AND CLEANING FILTER ELEMENT
When the new filter is first placed into service, note the read-
ing on the pressure gauge. As dirt builds up in the filter, the
pressure reading will increase. When it reads 10 psi above
the original reading, the filter element should be cleaned as
described below or replaced.
Filter Element Cleaning
1. STOP pump.
2. Close inlet and outlet valves if installed (for units below
water level).
3. Loosen the yellow air vent on the top of the filter.
4. Remove the Ring-Lok. Push in the top of the yellow lock-
ing tab as you begin to rotate the Ring-Lok to allow removal.
5. Using the Lid Removal System tabs on the bottom side of
the nut, remove the cover by inserting the tabs between the
cover and the body and rotating the nut allowing the tabs to
pry the cover upward.
6. Grasp the filter element by its upper edges and remove it
from the support pipe.
7. The element can usually be cleaned with a high pressure
nozzle on a garden hose. Place the nozzle inside the car-
tridge and spray outward pushing any trapped debris from the
cartridge.
TIP: For optimum cleaning, allow your cartridge to dry. Brush
off the remaining dirt and chemicals that will not wash off with
the hose. As additional cartridge will allow you uninterrupted
enjoyment of your pool during this cleaning procedure.
INSTALLING FILTER ELEMENT
1. Remove and clean the o-ring on the filter body and lubri-
cate with petroleum jelly. Also, clean the o-ring groove on the
filter body and the sealing surface inside the filter cover to
ensure a leak-free seal. Install the o-ring on the filter body.
2. Clean the dirt catcher at the bottom of the support tube.
This assembly can be removed if desired by lifting upward on
the support tube while rocking it from side to side. Once clean,
replace it by firmly pushing it back into the filter body.
3. Slide the clean filter cartridge back onto the support tube
and press it firmly into place.
4. Place the cover on the filter body and press firmly down-
ward until it seats.
TIP: It is easier to replace the cover if the air bleed
valve is open.
5. Clean the threads of the Ring-Lok nut and the threads on
the filter body with water or a clean rag. Place the Ring-Lok
nut on the filter and tighten to the built-in stops on the threads.
Be sure the yellow locking tab is fully engaged.
SERVICE & REPAIR PARTS
Refer all service to your local dealer as his knowledge of
your equipment makes him the best qualified source of in-
formation. Order all repair parts through your dealer. Give
the following information when ordering repair parts:
Unit nameplate information and description of part.
If the recommendations in the "Questions?" portion of
this manual do not solve your particular problem, please con-
tact your local dealer for service.
3