Gama Sonic 106B133 Gebrauchsanweisung - Seite 3

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Lantern Gama Sonic 106B133 herunter. Gama Sonic 106B133 4 Seiten. Baytown bulb solar lamp

Seite drucken

Operation Instructions

Fig. 1

1. Remove the Top (B) from Body part (C) by unscrewing the 2 screw caps. Install the new GS Solar LED Light Bulb by

turning it into the bulb socket located at the top of the light clockwise. Bulb needs to be installed before lamp is

turned on.

NOTE: When installing the GS Solar LED Bulb, hold it from its silver base not by the glass (Fig.3)

2. Turn the operation switch (Fig. 2) to either High or Low position according your preferences. The Solar Lamp will

automatically operate dusk to dawn.

3. Reattach the Top part (B) to the Body part (C) and secure with the 2 screw caps.

Installation Instructions

NOTE: There are specific types of screws for specific

surfaces. If unsure of the appropriate type of screw to use

on your desired surface please consult a professional.

Pier Mount

Using the base as a template,use a drill to make two

holes in the desired surface

2. Place the white screw anchors into the holes, place

the lamp in line with the holes and secure with the

provided screws.

3. Screw in part G into part C as shown in Fig. 1.

Wall Mount

NOTE: For best results, place your lamp in a spot facing

south.

Remove the silver bracket by removing the 2 screw

caps on the front face of the wall mount.

page 3

Fig. 2

2. Screw the silver bracket onto the desired surface.

3. Place wall mount onto bracket and replace 2 wall

mount screw caps.

4. Slide part E through Part D as shown in Fig. 1.

5. Attach Part C to Part D by turning part E clockwise.

3" Fitter Mount

NOTE: If you are replacing an existing gas/electric post

light, you must consult a certified technician to cancel

them before installation.

Screw part F into part C as shown in Fig. 1.

2. Position Part (F) on top of the existing 3" post and

tighten it using the screws provided. Tighten the 3 set

screws - do not over-tighten.

Fig. 3