DynoSense DYNO 50 Gebrauchsanweisung Handbuch - Seite 7
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung Handbuch für Medizinische Ausrüstung DynoSense DYNO 50 herunter. DynoSense DYNO 50 13 Seiten. Vital sign measuring system
Auch für DynoSense DYNO 50: Gebrauchsanweisung Handbuch (13 seiten)
Seite drucken
9. CLEANING INSTRUCTIONS
Alcohol Wipe
Use alcohol wipe to clean the surface of the device. IPA (70% isopropyl
alcohol) based alcohol wipe packets should be used for cleaning.
Rinsing
Rinse ONLY the mouthpiece with war m water before and after every
use. Do not submerge in water. After rinsing, be sure to shake the
device for a few seconds for any water trapped in the mouthpiece to
drip out. W ipe the device with alcohol wipe afterward and before place
the glass cover.
10.
CHARGING INSTRUCTIONS
1.
Plug the small end of the charging cable into the charging base,
and then plug the other end of the cable into a USB power supply or a
computer USB port.
Device is powered and
Solid green
fully charged
Device is charging
Solid orange
11.
STORAGE INSTRUCTIONS
Make sure to place glass cover on device to keep the device off. The
device battery will gradually drain if the device is not covered.
The device with the glass cover should be stored in room temperature
and not exposed to excess heat.
12.
SAFE DISPOSAL INSTRUCTION
Do not dispose the device in unsorted municipal waste. This device
should be retur ned to the distributor in case of damage.
For support, please contact at +1-650-397-6103 or visit www.dynosense.com
All manuals and user guides at all-guides.com
12
13.
TROUBLESHOOTING
Problem
Possible Cause
Device does
Low Battery
not tur n on, no
status indicator
No valid heart
No valid ECG data
rate/ECG on
collected
result screen
(HR ----/ECG---)
No valid
No valid
respiration rate
respiration data
on result screen
collected
(Resp Rate ----)
No valid SpO
No valid pulse
2
data on results
oximetry data
screen
collected
(SpO
---)
2
Temperature
Ther mometer tip is
reading too low
not making a good
contact or too
much movement
The App can't
Device is not on
find the device
when trying to
add new device
Bluetooth
Mobile device
connection failed
Bluetooth problem
"Can't connect
No server/
to Cloud"
No inter net
connection
For support, please contact at +1-650-397-6103 or visit www.dynosense.com
Solution
Charge the battery and try again.
If the problem persists contact the
distributor.
Try a new data collection/capture
by wetting your lips. Pay attention
to the on-screen data collection
progress indicator.
Breathe nor mally through the nose.
Reinsert the left index finger under
the flap. Hold the device steadily
and gently without too much
pressure. Repeat the measurement.
War m your finger prior to use.
Repeat the measurement by
pressing tongue against the
ther mometer tip. Do not move
the ther mometer tip during the
measurement.
Make sure the device is taken out
from the charging base and is on.
Device status indicator should be
blinking green.
Tur n off and tur n on the Bluetooth
of your mobile device.
1. Make sure you are connected to
the inter net.
2. If the inter net connection is not
good, please try again.
13