Maintronic Sx2 Tuning-Dongle Installationshandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installationshandbuch für Zubehör für Fahrräder Maintronic Sx2 Tuning-Dongle herunter. Maintronic Sx2 Tuning-Dongle 5 Seiten. For ebike; with bosch active / bosch performace line cablekit sx2kb-perf

Is an extension of the connection cable possible?
ANSWER:
Yes, with a commercial standard headphone extension
cord, the Sx2 Tuning-Dongle can be placed anywhere on
the eBike.
Return consignment
The return form has to be filled out step by step with
an exact error description. A purchase receipt has to be
included. You need to send our product back in a passed
envelope.
Waste disposal
In accordance with European Directive 2002/96/EC
(it`s) not longer usable electronic devices and defective
or used batteries (European Directive 2006/66EG) must
collected separately and disposed by an environmen-
tally sound recycling.
Please make sure not to dispose the Sx2 Tuning-Dongle
in your household waste.
© 2017 - maintronic® GmbH reserve the right to make
technical changes and product improvement
without prior notice.
Mistakes and typing errors reserved.
All rights reserved.
MTC maintronic GmbH
Tel: +49 (0)9721-766-0
Carl-Zeiss-Str. 10-14
www.maintronic.de
D-97424 Schweinfurt/Germany
5
Fehleranalyse
If the cablekit is connected but the dongle has no operation,
it´s possible the cablekit does not have the right connection or
the voltage is not enough.
To make sure the connection is ok, the present voltage and cur-
rent can be checked with a measurement device.
Please note !!! The magnet of the speedsensor may not ex-
ceed over the Sensor during the measurement.
Voltage measurement:
Therefor is the best way to take a 3.5mm stereo jack with two
male connectors and measure according to the below connec-
tion diagram.
Between the tip and the front ring has to be +5VDC. The tip of
the jack is Ground.
Check present
+5.0 VDC
voltage with
measurement
V=
device.
COM
+ VDC
+5V
- Ground
10
orange(+12V)
red (+3V)Sensor
black
(- Ground) Sensor
3.5mm Stereo jack cable
male connector to male connector
When it´s plugged in with a Y-adaptor the proper working of
the dongle can also be checked. Is the dongle plugged in, the
voltage reduce to approximately 4.5 V.
Current measurement:
A current between 5mA and 10mA are necessary. The currrent
is measured also between tip and front ring. The tip of the
3.5mm jack is ground.
Important: The measument device has to set on the function
current and the + measurement line plugged into the provided
socket.
Check present
6.0 A
current with
measurement
A=
device.
COM
schwarz
ADC
(- Ground) Sensor
3.5mm Stereo jack cable
male connector to male connector
ca. 5-10,0 mA
- Ground
orange(+12V)
rot(+3V)Sensor