Adex ISAIX16 Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Extender Adex ISAIX16 herunter. Adex ISAIX16 13 Seiten. Isa bus isolation extender
Seite druckenISAIX16 User's Manual
FUSE and PIN HEADER DEFINITION
Fuse Socket
EXTERNAL POWER
4
3
FUSED POWER
2
SYSTEM POWER
1
W1
+5V
W2
-5V
W3
+12V
W4
-12V
W6, Speaker Jumper
Jumper in -
Speaker will buzz at approximately once per
second during normal operation while bus signal
and power is fully connected. It will also generate a
continuous tone if logic detects a short circuit
condition.
Jumper out -
Speaker will not buzz during normal operation, but
will still generate a continuous tone if logic detects
a short circuit condition.
To adjust the volume of the speaker, turn the trim pot by the
speaker. Turn counter clockwise to increase the sound and turn
clockwise to decrease the sound.
Adex Electronics
-6-
ISAIX16 User's Manual
W7 Pin Headers
1 2
9 10
1
#Power_Control (Internal)
2
+5V
3
#Signal_Control (External Input, Low enable)
4
Key
5
#Power_Control (External Input, Low enable)
6
Gnd
7
Gnd
8
Power_Control (External Input, High enable)
9
LED-
10
LED+
# indicates low active input.
Pin 1 and pin 3 are jumped together in default to allow single
toggle switch operation, which both power and bus signals are
turned on together. User may connect an external toggle switch
to pin 5 or an external TTL high signal to pin 8 to control the
board.
To control the bus signals separately from the bus power, remove
the jumper at pin 1 and pin 3 and connect external TTL control at
pin 3. Power should be connected first, then the bus signals.
The on-board toggle switch should be at down (off) position, if
external TTL control is used.
Adex Electronics
-7-