Maiwe MIEN6218-2F Benutzerhandbuch - Seite 12
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schalter Maiwe MIEN6218-2F herunter. Maiwe MIEN6218-2F 20 Seiten. Industrial ethernet switch
Seite drucken
MIEN2216/18/20&MIEN6216/18/20 Industrial Ethernet Switch
RUN
LINK/A
CT
SPEED
6. 100M fiber port interface
This series of products have 0/2/4 100Base-FX full-duplex single-mode or
multi-mode fiber ports, and the interface format can be SC, ST or FC. Fiber
ports need to be used in pairs (TX and RX are a pair), TX port is the optical
transmitter, which is connected to the optical port of another remote switch.
Receiving end RX; RX port is the optical receiving end, which is connected
to the optical transmitting end TX of the optical interface of another remote
switch. Two pairs of redundant 100Base-FX optical fiber interfaces can be
used to form an optical fiber redundant ring network. When the system fails,
the ring network redundancy switching time is less than 20ms, which can
effectively improve the reliability of network operation.
The 100M optical interfaces mainly include: SC, ST, FC.
7.Ethernet RJ45 port
This product has multiple RJ45 10Base-T/100Base-TX Ethernet ports.
Each RJ45 port with auto-negotiation, auto MDI / MDI-X connection. Internet
can be used straight line / cross-over cable to connect the switch to terminal
equipment, servers, hubs or other switches. Each port supports IEEE802.3x
adaptive, so the optimum transmission mode (half or full duplex) and data rate
(10Mbps or 100Mbps) can be automatically selected (the connected devices
must also support this feature). If the device is connected to these ports do not
On
Equipment operate nomal
Off
Equipment abnormal
Port has established a valid network
On
connection
Blinking
The port is in network communication state
The port has not established a valid
Off
network connection
On
Indicates the maximum rate
No connection or not reaching the
Off
maximum rate
- 8 -