CentralPneumatic 69927 Benutzerhandbuch - Seite 16

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Nagelpistole CentralPneumatic 69927 herunter. CentralPneumatic 69927 20 Seiten. Framing nailer 28 angle

Seite drucken

Troubleshooting

Problem

Insufficient

1. Incorrect tool depth setting.

fastener depth.

2. Not enough air pressure.

3. Incorrect lubrication or

not enough lubrication.

4. Blocked air inlet screen

(if equipped).

5. Mechanism contaminated.

Fasteners drive

1. Incorrect tool depth setting.

too deeply.

2. Too much air pressure.

Tool cycles

1. Jammed fastener.

without firing

fastener.

2. Tool empty.

3. Incorrect fasteners used.

4. Magazine dirty or not

lubricated properly.

5. Insufficient air flow.

Frequent

Incorrect nail type.

jamming.

Severe air

1. Cross-threaded housing

leakage.

components.

(Slight air leakage

is normal,

2. Loose housing.

especially on

older tools.)

3. Damaged valve or housing.

4. Dirty, worn or damaged valve.

Follow all safety precautions whenever diagnosing or servicing the tool.

Disconnect air supply before service.

Page 16

Possible Causes

For technical questions, please call 1-800-444-3353.

Likely Solutions

1. Adjust depth setting, if available.

2. Check for loose connections and make sure that

air supply is providing enough air pressure (PSI) to the

tool's air inlet. Do not exceed maximum air pressure.

3. Lubricate using air tool oil and grease

according to directions.

4. Clean air inlet screen of buildup.

5. Have qualified technician clean and lubricate

mechanism. Install in-line filter in air supply

as stated in Initial Set Up: Air Supply.

1. Adjust depth setting, if available.

2. Reduce air supply pressure (PSI).

1. Clear jammed fastener according to

Clearing Jams instructions.

2. Reload with correct fasteners.

3. Empty, then reload with correct fasteners.

4. Clean and lubricate magazine and pusher.

5. Check for loose connections and make sure that

air supply is providing enough air flow (CFM)

and pressure (PSI) to the tool's air inlet.

Do not exceed maximum air pressure.

Confirm nail collation type, diameter, angle,

type, and length. Correct as needed.

1. Check for incorrect alignment and uneven gaps.

If cross-threaded, disassemble and

replace damaged parts before use.

2. Tighten housing assembly. If housing cannot tighten

properly, internal parts may be misaligned.

3. Replace damaged components.

4. Clean or replace valve assembly.

Item 69927

69928