CentralPneumatic 62541 Benutzerhandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Säge CentralPneumatic 62541 herunter. CentralPneumatic 62541 16 Seiten. High speed metal saw
Seite druckeninitial tool Set up/assembly
read the entire iMpOrtant SaFety inFOrMatiOn section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual�
note: This air tool may be shipped with a protective plug covering
the air inlet� Remove this plug before set up�
air Supply
tO preVent SeriOuS inJury FrOM eXpLOSiOn:
use only clean, dry, regulated, compressed air to power this tool.
Do not use oxygen, carbon dioxide, combustible gases,
or any other bottled gas as a power source for this tool.
1� Incorporate a filter, regulator with pressure
gauge, oiler, in-line shutoff valve, and quick
coupler for best service, as shown on
Figure A and Figure B on page 9� an
in-line shutoff ball valve is an important
safety device because it controls the air
supply even if the air hose is ruptured.
the shutoff valve should be a ball valve
because it can be closed quickly.
note: If an automatic oiler system is not used,
add a few drops of Pneumatic Tool Oil to the
airline connection before operation� Add a few
more drops after each hour of continual use�
2� Attach an air hose to the
compressor's air outlet� Connect the air
hose to the air inlet of the tool� Other
components, such as a coupler plug
and quick coupler, will make operation
more efficient, but are not required�
WarninG! tO preVent SeriOuS
inJury FrOM acciDentaL OperatiOn:
Do not install a female quick coupler
on the tool. Such a coupler contains
an air valve that will allow the air tool to
retain pressure and operate accidentally
after the air supply is disconnected�
note: Air flow, and therefore tool performance,
can be hindered by undersized air
supply components� The air hose must be long
enough to reach the work area with enough extra
length to allow free movement while working�
Page 8
For technical questions, please call 1-888-866-5797.
3� Release the throttle�
4� Close the in-line shutoff valve between
the compressor and the tool�
5� Turn on the air compressor according to
the manufacturer's directions and allow it
to build up pressure until it cycles off�
6� Adjust the air compressor's output
regulator so that the air output is enough
to properly power the tool, but the output
will not exceed the tool's maximum air
pressure at any time� Adjust the pressure
gradually, while checking the air output
gauge to set the right pressure range�
7� Inspect the air connections for leaks�
Repair any leaks found�
8� If the tool will not be used at this time, turn off
and detach the air supply, safely discharge
any residual air pressure, and release the
throttle to prevent accidental operation�
note: Residual air pressure should not be
present after the tool is disconnected from
the air supply� However, it is a good safety
measure to attempt to discharge the tool in a
safe fashion after disconnecting to ensure that
the tool is disconnected and not powered�
Item 62541