Bristan Dune Montageanleitung & Inhaltsverzeichnis - Seite 4

Blättern Sie online oder laden Sie pdf Montageanleitung & Inhaltsverzeichnis für Sanitärprodukt Bristan Dune herunter. Bristan Dune 8 Seiten. Standard toilet seat

Seite drucken

3. Installation

Please read carefully before attempting to fit the seat. If you are not the end user, please make sure the aftercare

instructions are made available for the end user to read.

A. Basic principle of hinge mechanism (see diagram A). The hinge body assembly is inserted into the hinge

mounting holes in the rear of the seat ring/lid and then bolted to the toilet pan.

B. Adjusting the seat hinges. In order to fit the seat correctly, it is essential to adjust the seat hinges. Adjustment

can be achieved in 2 main ways.

1. Rotation of the hinge discs (see diagram B). By rotating the disc on the underside of the hinge body assembly, it

is possible to adjust the position of the fixing bolts. In addition to this rotating action, by sliding the fixing bolt

up/down the slot in the disc, it is possible to adjust the fixing bolt position further. The combined rotating/sliding

action allows a wide range of fixing positions. This is necessary in order to match the distance between the 2

holes in the toilet pan and to adjust the forward/backward position of the seal.

NOTE:- It is necessary to make sure that the hinge body assemblies are fully inserted into the hinge mounting

holes in the seat (as in diagram A). Failure to do so will result in excessive side to side movement of the seat.

Some side to side movement is perfectly normal.

2. Swapping over the hinge body assemblies (see diagram C1 and C2). It can be seen that the hinge body

assemblies are handed and that the angled bar is positioned off centre in relation to the assembly. By swapping

the hinge bodies over, it is possible to move forward (as in diagram C1) or backwards (as in diagram C2) on the

toilet pan.

C. Bolting the seat to the pan (see diagram A). It is essential that:-

1. All washers are fitting (as in diagram A). NOTE:- That the main seat washer must be fitted the correct way up.

2. The locking nuts are tightened properly. This may require the use of pliers. Failure to adequately tighten the

locking nuts may result in the seat moving around the pan - care must be taken however not over

tighten the nuts as this could either strip the thread in the nut or damage the toilet pan. After a few days

use, check that the nuts are still tight – this is necessary as the washers will slowly compress in the first few days

of use. If the seat lid or ring will not stay in the raised position then move it further on the pan.