Bristan GLL FLEXSNK C (D1) Installationsanleitung & Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationsanleitung & Benutzerhandbuch für Sanitärprodukt Bristan GLL FLEXSNK C (D1) herunter. Bristan GLL FLEXSNK C (D1) 2 Seiten.
Seite drucken
General Cleaning
Your fitting has a high quality finish and should be treated with care to preserve the visible surfaces.
All surfaces will wear if not cleaned correctly, the only safe way to clean your mixer tap is to wipe with a
soft damp cloth. Stains can be removed using washing up liquid. All bath cleaning powders and liquids
will damage the surface of your fitting, even the non-scratch cleaners.
Note: Never use abrasive detergents or disinfectants or those containing alcohol,
hydrochloric acid or phosphoric acid.
Maintenance - Cleaning/Replacing Cartridge
2
1
Remove
cap.
Undo grub
screw and
remove
handle.
IMPORTANT
2.5
Isolate the
mm
water supply
5
Replace
before starting!
cartridge.
4
Screw on retaining
nut and shroud.
Troubleshooting
Symptom
Cause(s)
Partially closed isolation valve.
Instantaneous water heater cycles on and off as flow
rate or pressure is too low.
Head of water is below the minimum distance required.
Hot or cold water being drawn off elsewhere causing
No flow or low
pressure changes or instantaneous boiler temperature
flow rate
changes.
Airlock or partial blockage in the supply pipework or
hoses.
Water supply failure
Hose is leaking due to aging/damaged O-Rings or
Anti-Friction seals
This is normal for a short time after using the taps.
Water
dripping from
If water continues to drip,
taps
possibly due to the ceramic disc valves/cartridge
Closed isolation valve.
Taps do not
turn on
Mains water supply turned off.
Handset
Site water pressure is too high for the working
Pressure
pressures listed on the specification.
Changes
3
Using a suitable tool,
remove shroud and
retaining nut.
Remove cartridge.
Place cartridge in a suitable
solution and soak until fully descaled.
6
Replace handle.
Tighten the
Turn on the
grub screw and
mains water
replace the cap.
supply, letting the
water flow for a few
minutes to flush
2.5
through the system.
mm
Remedy
Open isolation valve.
Increase water flow rate or
pressure through system.
Check the site has the required working
pressures according to the specification.
Do not use other water outlets when using the
taps.
Flush through pipework to ensure removal of
debris and any airlocks.
Investigate water supply. Check your plumbing
and heating systems for any faults.
Call Customer Services for replacement seals
This is caused by residual water tension,
the build up of water in the tap body.
Remove valves/cartridge and clean, refer to
'Maintenance' section before starting any
maintenance.
Open isolation valve.
Turn on mains water supply.
Install a Pressure Reducing Valve in order to
achieve working levels of pressure.
Notes
Please use this space for any notes you or your installer may have
regarding the installation/plumbing of this product.
At Bristan, we want to make things as easy as possible for our customers. That's why we offer solid guarantees on
all our products, effective from the date of purchase, to give you peace of mind.
To start your free guarantee simply scan the QR code and register your product.
Alternatively visit www.bristan.com/register.
For any other queries, please call our Customer Service on 0330 026 6273 where our expert team of advisors
will be able to offer you any help and advice.
For full guarantee terms and conditions visit www.bristan.com/guarantees.