Majestic GATEWAY X5535D Montageanleitung

Blättern Sie online oder laden Sie pdf Montageanleitung für Musikinstrument Majestic GATEWAY X5535D herunter. Majestic GATEWAY X5535D 2 Seiten. Gateway series

Seite drucken

GATEWAY SERIES

Assembly Instructions for M5533D X5535D

Check Contents

1. Tone Bars (naturals & accidentals)

2. Keyboard Frame

3. Z-Stands (legs & crossbar)

4. Resonator Set (optional)

5. Upgrade: add-on wheel (optional)

Assembly leg stand

Setup Z-stand by adjusting height on upright legs. Loosen knob, Slide the pin in

position, and then tighten the knob. (match height on both upright sections) If M5533

Resonators are used, must keep 5 pin holes or more open. Connect crossbar to the

middle of each upright leg, secure the crossbar by tightening each knob.

For X5535 Xylophone

For M5533 Marimba

x 2 st

x 1 pc

x 1 st

x 2 pc

For more information please visit

http://www.majestic-percussion.com

Attach Keyboard frame & Resonators (optional)

1. Fit the round rubber feet under the frame with the slots on top of each Z leg and

Slide-in to attach.

2. Attach resonator set by hanging each end on the rubber brackets at inner

side of keyboard frame. (the full resonator section is for the naturals and the

staggered resonator section is for the accidentals)

Attach bars to the frame

1. Unroll the tone bars carefully, holding the cord from both ends, place the bars

onto the frame.

2. Align bars between each post, slide cord into the ring of each post. (Attach the

naturals first, followed by the accidentals)

3. Pull the cord at the low register end to a medium tension. And then connect the

springs. (adjust the knot at each spring to adjust tension)

Ver.201212