Bristan Options Bath Montageanleitung & Inhaltsverzeichnis - Seite 2

Blättern Sie online oder laden Sie pdf Montageanleitung & Inhaltsverzeichnis für Sanitärprodukt Bristan Options Bath herunter. Bristan Options Bath 2 Seiten.

Seite drucken
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for
optimum use both the hot and cold supplies should be reasonably
balanced. If the fitting is installed at low pressure (tank fed), then
the minimum distance from the outlet of the nozzle to the underside
of the cold tank should be 2 metres to ensure adequate
performance. This equates to a minimum operating pressure of 0.2
bar.
This mixer should be installed in compliance with Water Regulations.
Where the supplies are unbalanced, i.e. hot water from the cylinder
tank / cold from the mains, approved check valves must be fitted in
the pipes. For further details contact your Local Water Authority.
CONTENTS
1.
Backnut
2.
Rubber Washer
3.
Body
Please Note: In the unlikely event you find a part missing please
contact our Customer Service Help line on 0844 701 6273 for
immediate dispatch of part.
(x2)
(x2)
(x1)
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Fit the mixer body to the bath securing the washers (2) and
backnuts (1) below the bath, then connect the hot and cold water
supplies.
3. Fit tap handles. Fitting varies depending on handle. Either
disassemble handle and use screw hidden under cap or secure
plastic adaptor to valve with screw and then push on handle.
NOTE: Handles must be bought separately.
4. Fully open the mixer valves, letting them run for a few minutes
and check all joints and connections for leaks.
5. See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
1.
Isolate water supplies.
2.
Disassemble/remove handle, unscrew retaining screw and lift
off the handle.
3.
Unscrew the valve. Carefully clean seating, rubber washer
and/or ceramic disc.
4.
Refit the valves, handles and tighten retaining screw. Replace
the top of the handle or handle indices.
5.
If problem persists contact our helpline quoting the product
code.