IKEA ENHET Installationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Installationshandbuch für Inneneinrichtung IKEA ENHET herunter. IKEA ENHET 16 Seiten. Kitchen
Auch für IKEA ENHET: Installationshandbuch (10 seiten), Installationshandbuch (20 seiten)

Seite drucken

Installing the plinth

Generally, the base cabinets are supported by the

supporting strip along the wall and two legs in the

front of the cabinet. However, if you are going for

a kitchen with a plinth you also need to consider

the following steps:

For a plinth setup place the legs with the leg-plate

aligned to the cabinet edge. Since the plinth is

attached via the legs, you also need an additional leg

at the back of the open cabinet sides.

For the front plinth, place the plinth in position and

mark where you should cut it. After you've cut it,

repeat the process of attaching the edge band and

the plastic fittings that connect with the leg.

Start with the plinth for the short side of the cabinet

and use a handsaw to cut a 552mm piece. Then sand

the open edge before you apply the pre-glued edge

band that comes with the plinth.

When two plinth sections meet, forming a corner,

you need to attach both plinth strips to the same leg.

In order to avoid the clips colliding, place the clips

upside down in one of the strips.

Follow the plinth assembly instructions to attach

the plinth. Remember to remove the plastic sleeves

from the leg since they will obstruct the attachment

of the plinth.

Note: ENHET open frames can't be combined with a

plinth. For ENHET frames, use ENHET legs for frame.