IKEA ENHET kitchen Installationshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationshandbuch für Inneneinrichtung IKEA ENHET kitchen herunter. IKEA ENHET kitchen 16 Seiten.

Use a spirit level to find the highest point of the

floor and mark where that is on the wall. This will be

the reference point from which to measure when

marking the key measurements (see below).

Marking key measurements

There are some critical measurements you need to consider and mark on your walls in order to secure proper

alignment, leave adequate room for your work area and follow appliances requirements. Remember to consider

the space needed for doors and drawers to open properly, making sure there are no collisions with for instance

radiators or window sills as drawers and doors are opened.

1. First mark 125 mm from the highest point (A) you

found at the very beginning and trace a horizontal

level line across your wall where the cabinets will

be placed. This base line represents the height of

the cabinet legs.

2. Second mark 878 mm from the floor and proceed

as before. This is where the top of your base

cabinets will end up.

Prepare your space by making sure your corners are

even and your walls and floor are straight. Use your

try square for the corners and a spirit level for the

walls and floor.

3. Finally, mark another line at 1466 mm from the

floor and trace a horizontal line as with the other

markings. This line represents the bottom position

of the wall cabinets and frames.

4. With the lines marked, double-check that your

plumbing and electrical outlets fit with your layout

plan.

5. Pay attention to the required minimum distance

between hob and hood. This can be found in the

extractor hood assembly instruction.

If your corner and/or walls aren't straight you may

need to use distances to make sure your kitchen

cabinets and frames become level and align properly.

For advice contact you local specialised dealer.

6. The dishwasher should only be installed between

two cabinets or at least between a cabinet and the

wall. This in order to secure the appliance properly

and provide support for the worktop.

7. If you have a kitchen with a corner, you build

the corner base solution with a regular 80 cm

base cabinet and an ENHET corner panel. For the

positioning of this solution, see page XX.