DecaLED 95312351 Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch für Controller DecaLED 95312351 herunter. DecaLED 95312351 6 Seiten. High power dmx controller tv

If you want to construct your own data cables, be sture to use standard two conductor shielded cable (this

cable may be purchased at almost all professional sound and lighting stores). Your cables should be made

with a 3-pin male and female XLR connector on either end of the cable. Also remember that DMX lines must

be daisy chained and can not be split.

Be sure to follow the figures 2 and 3 below when making your own cables. Do not use the ground lug on the

XLR connector. Do not connect the cable's shield conductor to the ground lug or allow the shield conductor

to come in contact with the XLR's out casing. Grounding the shield could case a short circuit and erratic

behavior.

Special note: Line termination

When longer runs of cable are used, you may need to use a terminator on the last unit to avoid erratic

behavior. A terminator is a 120 Ohm 1/4W resistor which is connected to pins 2 and 3 of a male XLR connector

(DATA+ and DATA-). This unit is inserted in the female XLR connector of the last unit in your daisy chain to

terminate the line. Using a cable terminator will decrease the possibilities of erratic behavior.

5-pin XLR DMX connectors

Some manufacturers use 5-pin XLR connector for DATA transmission in place of 3-pin. 5-pin XLR fixtures may be

implemented in a 3-pin XLR DMX line. When inserting standard 5-pin XLR connectors in to a 3-pin line a cable

adaptor must be used, these adaptors are readily available at most electric stores. The chart below details a

proper cable conversion:

Controls and functions

Rear panel layout

Power input: AC100~120V (3.2A) / AC220~240V (1.2A), 50~60Hz

Voltage selector: AC120V/230V optional by this voltage selector