Bristan PM SQSHXDIV C Montageanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Kontrolleinheit Bristan PM SQSHXDIV C herunter. Bristan PM SQSHXDIV C 6 Seiten. Prism single control surface mounted shower valve with rigid riser & diverter to handset

Seite drucken

Installation

Using complete valve and kit (see fig.1 on previous page)
1) With the shower mixing valve installed, connect the rigid riser (with brackets and slider) onto
the valve using the extension tube. Ensure all seals are correct.
Note -
Prior to drilling the wall for the wall brackets ensure adequate movement can be achieved
from the handset holder.
2)
Use the brackets as a guide for the wall connection. Mark/ drill and plug holes to suit wall
brackets and fix into place using fittings. Secure into place by screwing the rod into the rail
and tightening the grub screw, using hexagonal key. See below.
Note -
The rod (see Wall Bracket Assembly) may both need to be cut to size in certain
installations.
3) Screw on the shower rose/ hose and handset using the washers supplied.
7
Installation
The installation, commissioning and maintenance must be carried out in accordance with
instructions supplied and be installed by qualified and competent persons. Installations
must comply with all Local and National Water Authority Regulations, and Building and
Plumbing Regulations.
Exposed Model (see fig.1, page 6)
1.
Determine the routes of the hot and cold supply pipework. The mixer can be fed from
the top, rear or bottom. See dimensions below for pipe inlet centres.
Note!
Ensure valve and rigid riser will fit without fouling the ceiling.
2.
Install supply pipework. Accessible isolating valves are recommended for
maintenance.
Note!
Try fit of mixing valve to pipework, each inlet elbow can be unscrewed 1½ turns to
allow for adjustment and location.
3.
Remove the wall bracket from the rear of the mixer by loosening retaining grubscrew
on the underside of mixer with the hexagon key.
4.
Use the wall bracket to mark hole positions. Drill wall and insert suitable wall plugs for
fixing screws.
5.
Fit bracket to wall using fixing screws. Ensure retaining hole for grubscrew is at the
bottom.
Important!
Ensure supply pipework is flushed to clear debris before connecting mixer. Do
not use sealing compounds on connections.
6.
Offer mixing valve to pipework and tighten the wall bracket retaining screw.
Lever orientation is for reference only.
Grubscrew
4