Majestic fireplaces 20011025 Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Zubehör für Kamine Majestic fireplaces 20011025 herunter. Majestic fireplaces 20011025 4 Seiten. Fuel conversion kit lp to natural/natural to lp for model dv360

WARNING!
The installation of this conversion kit must only
be undertaken by a qualified, certified gas appli-
ance installer.
Tools required for conversion: TORX T20 Security Tee
bit, 3/8", 1/2" deep well socket, Phillips or Robertson
screwdriver, 5/32" Allen wrench.
Check Contents of Shipping Carton
Compare contents of Figure 1 with actual parts re-
ceived. If any parts are missing or damaged, contact
your dealer before starting conversion.
Conversion Precautions
Allow unit to cool if it has been in operation.
Before proceeding, turn control knob on valve to "OFF"
and turn gas supply OFF. Turn OFF any electricity that
may be going to the appliance.
CAUTION: Logs may be HOT! Allow to cool before
proceeding.
Regulator
Dual Spring
Assembly - NG
Dual Spring
Assembly - LP
LP Bracket/
Gasket
Assembly
Fig. 1 Carton contents.
Conversion Instructions
1. Open louvre assembly bottom to gain access to
valve. Remove window frame assembly. (Refer to
Homeowner's Manual)
Fuel Conversion Kit
Installation Instructions
Kits: LP to Natural 20010751
Natural to LP 20010752, 20011025
for Model: DV360
Conversion Label Burner Orifice
(Refer to Table 1
to confirm sizes)
Pilot Orifice
Gasket
Pilot
Orifice
(RF Valve)
Plug -
Red (LP),
Blue (NG)
CAR179
CAR179
DV360
fuel conversion
2/06 djt
2. Remove logs if previously installed.
Honeywell Valve
1. Remove cap from HI/LO knob. This can be accom-
plished by lifting the plastic cap off the screw. (Fig. 2)
2. Remove the screw from center of HI/LO knob with
small screwdriver turning counterclockwise. (Fig. 2)
Cap
Lift Open
Hi/Lo
Knob
Fig. 2 Remove center screw from Hi/Lo knob.
3. Insert conversion screw supplied in conversion kit.
Blue for natural gas, red for LP.
4. Tighten screw, replace cap.
NOVA SIT820 Valve
1. Using the TORX T20 bit, remove and discard the
three (3) pressure regulator mounting screws (A),
pressure regulator tower (B) and the spring and
diaphragm assembly (C). (Fig. 3)
Fig. 3 Remove mounting screws, pressure regulator tower
and spring and diaphragm assembly.
Remove Center Screw
CO100
Gas conversion
HI-LO knob
3/15/99 djt
A
B
C
FC107
20010843 3/08 Rev. 4
FC107
SIT820
valve conversion
10/03
CO100
1