Gamma 5003 Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Besaitungsmaschinen Gamma 5003 herunter. Gamma 5003 20 Seiten. 6 point mounting
Auch für Gamma 5003: Benutzerhandbuch (20 seiten), Benutzerhandbuch (19 seiten), Benutzerhandbuch (20 seiten)

Seite drucken

1. Machine Parts

TENSION CALIBRATION

Tension Calibration Procedure

Step 1

Set the tension to 60 lbs. as indicated by the

linear scale and rotary knob. Place the string

on one end of a tension calibrator into a string

clamp and secure. Place string located on the

other end of the calibrator into the string

tensioner and apply tension. If the brake lever

releases before 60 lbs. or after 60 lbs., the

tension head should be calibrated as follows.

Step 2

Loosen the 1.5 mm locking set screw (A)

located on the side of the latching block as

shown. The set screw is used to hold the

adjustment screw in place.

Step 3

If the lever releases before 60 lbs., using the

supplied L-shaped hex wrench, turn the ad-

justment screw (B) located on the left side of

the latch block counter-clockwise to increase

the engagement of the brake release latch

with the brake lever. Repeat step 1 and

adjust until the correct tension is indicated

on the calibrator.

If the tension indicated in step 1 is greater

than 60 lbs., turn the adjustment screw clock-

wise to reduce the engagement of the brake

release latch with the brake lever. Repeat

step 1 and adjust until the correct tension is

indicated on the calibrator.