Gamma Progression Els Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Besaitungsmaschinen Gamma Progression Els herunter. Gamma Progression Els 20 Seiten.
Auch für Gamma Progression Els: Benutzerhandbuch (20 seiten), Benutzerhandbuch (19 seiten)

Seite drucken

MAINTENANCE & ADJUSTMENTS

cleaned periodically to be free from dirt, oil, and any string coating residue to grip properly.

Knife sharpening stones are excellent for removing build-up on the diamond coated surfaces

and are available.

Note: The string clamps supplied with your stringing machine can accommodate tight string

patterns such as badminton. Depending on the string pattern, the clamp may spread the

strings slightly which will not compromise the quality of the string job. String clamps designed

specifically for badminton racquets are available.

Adjusting the String Clamp Jaw Spacing

The string clamps will need minor adjustments according

to what string type, construction, and gauge you are using.

To adjust the gap (clamping pressure) between the clamp

jaws, insert the string through the racquet as if you were

beginning the main strings. Clamp the strings and pull

tension. If the string slips through the jaws of the clamp,

tighten the clamp by squeezing the clamp jaws together by

hand while turning the Adjustment Knob, in the clockwise

direction. If the clamp leaves impressions or damages the

string, it may be excessively tight and should be adjusted

Adjustment

Knob

by turning the Adjustment Knob counter clockwise to open

the gap between the jaws. The clamp jaws should be

Clamp Base Locking Nut Adjustment

In the event the Locking Lever rotation is

insufficient to ensure smooth operation of the

clamp base, very minor adjustments to the

Clamp Base Locking Nut can be made with

the supplied 17mm socket. Tighten or loosen

the locking nut in very small increments to

provide more clamping pressure or running

clearance as needed.

Quick Action Clamp Base Removal

Quick Action clamp bases can be removed

from the turntable for maintenance or cleaning

by removing clamp stop located at the end

of the slot in the turntable. To remove the

clamp stop, remove the two screws holding

the clamp stop in place from the underside of

the turntable. Lift the clamp stop out of the

slot, slide the clamp base to the end of the

slot and lift it out. Replace the clamp base

and clamp stop in reverse order.