Gamma PROGRESSION ST Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Besaitungsmaschinen Gamma PROGRESSION ST herunter. Gamma PROGRESSION ST 19 Seiten.

A - Cover Screws

C - Brake Adjustment Bolt

peat steps above until properly adjusted. After adjustment is complete, replace the tensioner

cover by aligning the holes of the cover with the holes in the tensioner frame and secure with

the 2 button head screws and flat head screw.

MAINTENANCE

B - Lock Bolt

Adjusting the Tensioner Brake - Step 1

After stringing many racquets, the brake of

the tensioner may need to be adjusted. To

tighten the braking mechanism, the cover of

the tensioner must be removed. To remove

the cover, remove the 2 button head screws

located on the back side of the tensioner

frame near the top of the frame, and the flat

head screw located behind the tensioner

lever on the back side of the tensioner frame

using the 3 mm hex wrench. With the brake

lever released remove the cover.

Adjusting the Tensioner Brake - Step 2

With the cover removed, and the brake lever

engaged, loosen the lower hex bolt located

on the back side of the tensioner frame with

the 10 mm box wrench. Note: The hex bolt

should only be loosened until loose enough

to turned by hand and must not be removed

completely.

Adjusting the Tensioner Brake - Step 3

With the hex bolt loosened and the brake

lever engaged in the latch, insert the 6 mm

hex wrench into the set screw locted inside

the nut located at the base of the brake lever.

To tighten the braking mechanism, turn the

set screw counter clockwise by about 1/8

tunr. Retighten the hex bolt on the back side

of the tensioner frame and check for brake

tightness. The tensioner should move freely

along the track with the brake lever engaged

and should hold tension with the brake lever

released. If more adjustment is needed, re-