IKEA SKYTTA Installationshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Installationshandbuch für Inneneinrichtung IKEA SKYTTA herunter. IKEA SKYTTA 16 Seiten.
Auch für IKEA SKYTTA: Installationshandbuch (16 seiten)

Seite drucken

1. Height Options

Door assembly

The door has two symmetrical side rails, bottom rail and top rail, marked with tape.

The wheel fitting is placed in the bottom and the guide fitting in the top. Click in the

horizontal bars on the side rails and spread them out so they match the height just

above the door filler panels. The guide pins with wings should be placed to match the

activator between doors.

DRAFT

Door fillers

The door filler panels are centred between the door side rails. Make sure that the panel

is inside the gasket flange. Never leave the panel without mounting the horizontal bar

or the top lid closed for the top panel. The plastic pin in the bar clicks in is to secure

that it can't be released.

Adjust door/activate soft close

By adjusting the wheel fitting's height, you can adjust the gap between the doors and

the door/wall. Release the two screws and turn the adjustment between the screws.

You have +/-2 mm (1/8") on each wheel.

The soft closing is activated by moving the door all the way to the wall. You will hear a

click, and after that the soft closing should work.

Top cover

The top cover is the same front and back and is clicked on the ceiling rail on both sides.

If you are connecting two top rails, make sure the cut end is towards the wall.

Mount door/clean floor rail

Clean the floor rail before mounting as dust can get stuck on the wheels. This should

be done regularly to maintain a nice sliding of the doors. Follow the layout with the

activator/soft closing. The guide pins with wings should be connected to the activator/

soft closing between doors.

Door handle

The door handle clicks into the door side rail. To get it into the correct position, the cut

out on the handle should match the plastic clip mounted on the backside of the middle

bar. This prevents the handle from moving vertically and makes all handles match in

height.

Home position middle doors

When a door has its closed position in the middle of the solution and not to a wall, you

mount the home position. The home position works together with the door guide and

activator. The home position has a wing nut that grips into the aluminum track during

assembly. Adjust by releasing the screw, slide to new position and tighten the screw.