decina FREESTANDING SPA BATH Installations- und Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installations- und Benutzerhandbuch für Sanitärprodukt decina FREESTANDING SPA BATH herunter. decina FREESTANDING SPA BATH 2 Seiten.
Seite drucken
INSTALLATION STEPS
1. Remove your freestanding spa bath from the carton & place it in the correct position for installation. Check for damage &
ensure your spa bath does not come in contact with any rough surfaces which may scratch your bath. Place it on cardboard or
carpet during installation.
2. Turn the self-leveling feet so the bath base is level & 3-5mm
above the finished floor.
A) Ensure there is a gap of 3-5mm between the bath shell & the
floor. Installing the bath shell directly onto the bath floor will place
pressure on the outside wall of the bath & can crack the bath.
B) Ensure the bath is level so all the water can drain to the
waste outlet.
3. Your freestanding spa bath is supplied fully plumbed & with
a 10AMP, 50HZ, 240V pump fitted with a 3-pin Power Plug.
Your freestanding spa bath will be required to either be
hardwired or plugged into a suitable power point.
For further guidance on the location of the power point &
any other electrical requirements, please discuss with your
licensed electrician.
4. Carefully tilt the spa bath on its side & connect it to the drain
outlet. We recommend using a Decina Flexible Connector.
Ensure the Flexible Connector is cut to the correct length for
easier installation & to prevent drainage issues.
5. Electrically connect your spa bath based on your electricians
directions.
6. Before finishing, water test for leaks & correct drainage.
A) Fill the freestanding spa bath with water & check the water
flows easily to the waste outlet.
NOTE a small amount of water may pool due to surface tension.
7. Apply a thick bead of silicon around the spa bath base & the
finished floor & allow it to set for 24 hours.
WARRANTY TERMS & CONDITIONS
All Decina products are manufactured to the highest standards and guaranteed to be free of defects, subject to the conditions outlined
below. In addition to the statutory rights given under Australian Consumer Law, Decina offers the following extended warranty periods
from the date of purchase or handover:
PRODUCT
FREESTANDING SPA BATH - Shell, Frame & Pipe Work 10 Years / 1 Year
FREESTANDING SPA BATH - Pump, Jets & Fittings
For full warranty terms & conditions, please visit the Decina website decina.com.au/warranty
To make a warranty claim, please visit the Decina website decina.com.au/warranty-claim/ or email [email protected]
PLEASE LEAVE THIS MANUAL WITH THE END USER. Copyright Oct 2019. Decina Bathroomware Pty Ltd. ABN 39845 084 033.
All dimensions are nominal & subject to manufacturing tolerances & may vary +/-5mm therefore we strongly recommend installation does not occur until after delivery. Decina reserves the right
to modify or change models without notice. For further information and for warranty T&C's, please visit decina.com.au or call 1300 332 462.
Decina Flexible Connector + Pop-Up Waste OWA004 Min. clearance 100mm
Decina Flexible Connector OWA005
WARRANTY
TERMS
Replacement Products / Parts & Labour
5 Years / 1 Year
Replacement Products / Parts & Labour
Min. clearance 80mm
Flexible Connector
Waste Outlet
Drain
DECINA.COM.AU
1300 DECINA
3-5mm