Centsys Photon SMART Installationshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationshandbuch für Sicherheitssensoren Centsys Photon SMART herunter. Centsys Photon SMART 8 Seiten.

7.4 Re-inserting the PCB

Tuck the base of the PCB into the ribs situated at the base

of the plastic enclosure. Thereafter swing the PCB into

place so that the top lever prevents it from falling out.

There should be an audible "click" to lock the PCB in

position. Refer to Figure 6.

7.5 Turning on the Receiver and Transmitter

The transmitter and receiver have been fitted with a

'power up' jumper. In order to preserve battery life,

the units have been packed with the jumper in the OFF

position.

To power them up, simply position the jumper so that it is

bridging the ON and COMMON pins as illustrated.

Receiver

7.6 Indicators

The Photon SMART has an LED which provides the user

with visual feedback, and is an alternative to using the

Mobile Application thereby making it easy to commission

the system.

To enter the Alignment Mode, the button shown in Figure

9 must be pressed for longer than 10 seconds; to indicate

that the 10 seconds have expired, the LED will turn off for

a short time and then turn on again.

During the alignment process, the LED will now remain on

if the Beams are aligned and the LED will turn off if the

Beams are misaligned or blocked.

To exit Alignment Mode, the button needs to be pressed

for 10 seconds until it turns on and off for a short time.

Jumper in OFF

position

Jumper in

ON position

FIGURE 6

Transmitter

FIGURE 7