Green Brook DH021A-C Anweisungen

Blättern Sie online oder laden Sie pdf Anweisungen für Zubehör Green Brook DH021A-C herunter. Green Brook DH021A-C 2 Seiten. Doorchimes & bell pushes instructions for wired

Seite drucken

Instructions for Wired

Doorchimes & Bell Pushes

MODEL NUMBERS -

DH020A-C

Galaxy Chime

DH021A-C

Tubular Chime

These products should be installed by a

competent person and in accordance

with the current IET Wiring Regulations.

If in doubt, consult a qualified electrician.

Bell Pushes -

If you have bought a bell push only

please go straight to step 3a. in these

instructions.

DP010A-C

Black Bell Push

DP020A-C

White Bell Push

DP220A-C

White Bell Push

DPL03A-C

Illuminating Black Bell Push

DPL04A-C

Illuminating White Bell Push

(DPL03A-C & DPL04A-C must be used with a

bell transformer)

This doorchime has a traditional

ding-dong sound and is easily fitted

for use with any bell push.

• Bell wire required

• Bell push required

An ornate bell push can be used if

preferred. (For illuminating bell

pushes a transformer must also be

used - GreenBrook model number

DAT01A)

• Fixing screws included

• Requires 3 x C cell LR14 batteries

(not included)

PLEASE READ THE FOLLOWING

INSTRUCTIONS FULLY BEFORE

ATTEMPTING INSTALLATION.

PREPARING BELL WIRE

1. Using a knife, carefully split the

bell wire down the middle to

form two separate wires, each

30mm long.

2. Strip each wire back to expose

5mm of copper wire.

3. The process will need to be

repeated at the other end of the

bell wire once it has been cut to

the required length.

4. The bell wire is now ready to wire

up the doorchime to the bell

push.

WIRING

YOUR DOORCHIME

1. Unclip top cover.

2. Thread bell wire from the back of

the base and through the large

opening to the left of the keyhole

slot.

3. Insert either one of the stripped

ends to terminal A and the other

to terminal C, ensuring the

terminal screws are tightened

securely afterwards. Do not use

terminals marked B and D.

4. Position the base on the wall

vertically, away from opening

doors, with the battery

compartment at the bottom.

Ensure that it is less than 5 metres

away from the bell push.

5. Use one of the screws and wall

fixings to hang the base on the

wall via the top keyhole slot.

Adjust the screw for a flush fit if

required.

6. Insert 3 x C cell batteries as per

markings on the inside of the

case.

WIRING

YOUR BELL PUSH

1. If necessary, remove the base

cover of the bell push to reveal

the terminal screws.

2. Loosen one of the terminal

screws and wrap one of the

stripped ends of bell wire around

the exposed screw thread,

ensuring the screw is tightened

securely afterwards. Repeat this

process for the other screw

terminal and wire.

3. Fix the base to the doorframe

using two of the screws and

fixings provided. Try to position

the door push in an unexposed

place to protect it from bad

weather.

4. Snap the cover back on if

appropriate.