KitchenAid Architect Series II KFGU766VSS Installationsanleitung Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Kochfeld KitchenAid Architect Series II KFGU766VSS herunter. KitchenAid Architect Series II KFGU766VSS 20 Seiten. 30" (76.2 cm) and 36" (91.4 cm) gas built-in cooktop
Auch für KitchenAid Architect Series II KFGU766VSS: Abmessungen (1 seiten), Handbuch der Abmessungen (1 seiten)
Seite druckenWARNING: If the information in this manual is not followed exactly, a fire or explosion
may result causing property damage, personal injury or death.
– Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
– WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call the fire department.
– Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the "What to do if you smell gas" instructions.
In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
If using a ball valve, it shall be a T-handle type.
A flexible gas connector, when used, must not exceed 3 feet.
Gather the required tools and parts before starting installation.
Tools needed
Tape measure
Flat-blade screwdriver
" (#0 [2 mm]) flat blade
screwdriver (screwdriver
shaft must be a minimum of
2" [5.1 cm] long)
" combination wrench
Pipe wrench
2
INSTALLATION REQUIREMENTS
Tools and Parts
Wrench or pliers
Needle-nose pliers
Marker or pencil
Pipe-joint compound
resistant to LP gas
Noncorrosive leak-detection
solution
Parts supplied
Gas pressure regulator
Burner grates
Burner caps
Clamping brackets (2)
2 " (6.4 cm) clamping screws (2)
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See "Electrical Requirements" and
"Gas Supply Requirements" sections.