DECKED Slide Handbuch für Installationsverfahren - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch für Installationsverfahren für Zubehör für Kraftfahrzeuge DECKED Slide herunter. DECKED Slide 6 Seiten. For midsize trucks

Seite drucken

HARDWARE NEEDED:

· 4 — 2" x 5/16" #18 bolts — McMaster.com part #91247A591

· 8 — 5/16" sealing washers — McMaster.com part #94708A413

· 4 — Thin hex nuts — McMaster.com part #91847A030

· 12 — 5/16" washers

CAUTION: Ignoring the sealing washers

could lead to water intrusion. If you plan on

using a tonneau or cap over the slide install,

you can omit using the sealing washers as

there won't be a water risk.

STEP 1

Place frame on DECKED system. Determine

if your slide frame's cross brace (the steel

strap mid-frame) mounting holes align

with the locations of the steel tubes in the

DECKED system. (The location of the steel

tubes in the deck halves are indicated by a

series of dimples).

STEP 2

If these holes do not align precisely on center

with the DECKED steel tube you will need to

either re-drill your slide frame's cross braces

or weld on another cross brace. Use same

thickness steel as manufacturer's (shown is

¼" thick x 2" wide). We spray-painted this

for rust prevention.

DECKED | 1

NOTE: Make

sure to use

bolts (rod

plus thread)

NOT screws

(thread only).