IKEA IBS324PWS0 Installationsanleitung Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Backofen IKEA IBS324PWS0 herunter. IKEA IBS324PWS0 12 Seiten. 24" (61 cm) electric built-in oven
Auch für IKEA IBS324PWS0: Handbuch für Gebrauch und Pflege (32 seiten)
Seite drucken
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
•
Phillips screwdriver
•
Measuring tape
•
Level
•
Hand or electric drill (for wall cabinet installations)
•
1" (25 mm) drill bit (for wall cabinet installations)
Parts needed
•
UL listed or CSA approved conduit connector
•
UL listed wire connectors
Parts supplied
•
Four # 8-14 x 1" screws
•
Four 4 x 13 mm screws
•
2 mounting rails
•
2 continuous-clean
panels and rack guides
•
Broil pan and grid
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
It is recommended
that all electrical connections
be made by a
licensed, qualified electrical installer.
IMPORTANT: Observe all governing codes and ordinances.
•
Cabinet opening dimensions that are shown must be used.
Given dimensions
provide minimum clearance with oven.
•
Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
•
Grounded electrical supply is required. See "Electrical
Requirements"
section.
•
Electrical supply junction box should be located 3" (7.6 cm)
maximum below the support surface when the oven is
installed in a wall cabinet. A 1" (2.5 cm) minimum diameter
hole should be located in the right rear or left rear corner of
the support surface to pass the appliance cable through to
the junction box.
NOTE: For undercounter
installation, it is recommended
that
the junction box be located in the adjacent right or left
cabinet. If you are installing the junction box on rear wall
behind oven, the junction box must be recessed and located
in the upper or lower right or left corner of the cabinet;
otherwise, the oven will not fit into the cabinet opening.
•
Oven support surface must be solid, level and flush with
bottom of cabinet cutout. Floor must be able to support a
single oven weight of 140 Ibs (63.5 kg).
Undercounter
Installation
(with cooktop
installed
above):
Ovens approved for this type of installation have an approval
label located on the top of the oven. Refer to undercounter
installation instructions for cutout dimensions and approved oven
cooktop combinations
(separate sheet).
Product
Dimensions
A
E
D
A. 21_%4"(54.5 cm) max. recessed
width
B. 2217/32 '' (57.2 cm) recessed height
C. 2327/64 '' (59.5
cm)
max.
overall
height
D. 21s/_6'' (53.8 cm) max.
recessed depth
E. 2327/64 ' '
(59.5
cm) overafl
width
Cabinet Dimensions
Oven Undercounter (without cooktop installed above)
E
B
A
_D_
A. 24" (61 cm) min. cabinet width
B. 11/_ '' (3.8 cm) min. top of cutout
to underside of countertop
C. 51/4" (13.3 cm) bottom of cutout to
floor
D. 22" (56 cm) cutout width
E. 23½_" (58.5 cm) min. cutout height
2