CenturionPro DBT 3 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Industrielle Ausrüstung CenturionPro DBT 3 herunter. CenturionPro DBT 3 16 Seiten. With variable speed control

Seite drucken

CONNECT POWER CORDS

1. Connect the DBT Model 3 power cord to a 15 amp 120 VAC circuit. Do not connect

and disconnect the power cord with wet hands. Do not operate in the rain.

NOTICE:

The DBT Model 3 draws a max of 5 amps.

STARTING THE MACHINE

1. Flip the MOTOR SWITCH to the ON position.

2. Turn the TUMBLER SPEED dial clockwise to set the desired speed, start off at the

lowest setting and increase as required.

STOPPING THE MACHINE

NOTICE: In an emergency, turn the motor switch to the OFF position.

1. At any other time, turn the TUMBLER SPEED dial counter-clockwise, until it aligns

with the ZERO.

2. Turn the MOTOR SWITCH to the OFF position.

DISCONNECT POWER CORDS

1. Disconnect the trimmer's power cord.

CONTROLS AND COMPONENTS

BEFORE OPERATION

Read and understand this manual. Educate yourself on the location and operation of the controls. Familiarize yourself with the trimmer and how

it works before you begin using it. Know how to quickly shut off the machine in case of an emergency.

Your safety is your responsibility.

PRE-OPERATION CHECK

For your safety, and to maximize the service life of your equipment, it is very important to take a few moments before you operate the trimmer to

check its condition before each use. If you happen to come accross any issues, be sure to take care of them before you operate the trimmer.

Improperly maintaining this trimmer, or failing to correct a problem before operation, could cause a malfunction which could cause you to be

seriously injured. Always perform a pre-operation inspection before each use, and correct any problem.

Before beginning your pre-operation checks, be sure the trimmer is on a level surface, the MOTOR SWITCH is in the OFF position, and all power

cords are unplugged.

CHECK THE GENERAL CONDITION OF THE TRIMMER

Clean the Tumbler, Blade Sheet, and tension system. Look for signs of damage.

Check each control for proper operation.

Check parts for wear. Replace if necessary.

Check that all nuts, bolts, and clamps are tightened appropriately.

NOTICE: Keep all shields, Trim Trays and covers in place while operating the trimmer.

1 855 535 0558

cprosolutions.com

BEFORE YOU START

SPEED CONTROL BOX

NOTICE:

Be sure to hold the plug when disconnecting power cord from

electrical outlet. Do not disconnect by pulling on the power cord.