Bermar BRC1001 Schritt-für-Schritt-Anleitung - Seite 6
Blättern Sie online oder laden Sie pdf Schritt-für-Schritt-Anleitung für Umrichterantrieb Bermar BRC1001 herunter. Bermar BRC1001 10 Seiten.
Seite druckenSTEP 3: Run the motor
The keypad can be used to edit drive parameters directly. For a guide to use the drive keypad, refer to
Figure 1-3.
Configure
Action
Detail
Power
Power the drive, ensure the drive is not enabled. (Display shows: inh)
1.
2.
Typically, the maximum frequency limit used is the motor rated frequency.
Enter
3.
4.
These parameters define ramp times between 0 Hz and Maximum Frequency Limit P0.02.
5.
Select
This parameter configures the drive speed control. See details within the Inverter BRC10 User
Guide.
6.
7.
Enter Motor
8.
Nameplate Details
9.
10. Enable/Run Configuration P0.10
Select
This parameter configures how to run the drive. See details within the Inverter BRC10 User
Guide.
Running and Speed Control (Default Configuration Settings)
Always ensure it is safe to start the motor before doing so.
Run
Provide an Enable signal to terminal 12 (T12).
Provide a run signal to T13 (Run Forward) or T14 (Run Reverse).
Increasing and
Increase or decrease current to Analog Input 1 (T2) to increase or decrease the frequency
Decreasing Motor
reference. Close Digital Input 5 (T15) to switch to a voltage reference from Analog Input 2 (T4).
Speed
Remove the Run Forward (T13) or Run Reverse (T14) signal to stop the motor by following the
Stopping
selected deceleration rate. If the Enable signal (T12) is removed while the motor is running, the
drive output is immediately disabled, and the motor will coast to a stop.
Troubleshooting
1.
Restore Factory
2.
Defaults
3.
If the drive detects a fault, it will display an error code. Please view the diagnostics section in the
Troubleshoot
Inverter BRC10 User Guide.
Inverter BRC10 Step by Step Guide
Minimum Frequency Limit P0.01 (Hz)
Maximum Frequency Limit P0.02 (Hz)
Acceleration Rate 1 P0.03 (s)
Deceleration Rate 1 P0.04 (s)
Frequency Reference Configuration P0.05
Motor Rated Current P0.06 (A)
Motor Rated Speed P0.07 (rpm)
Motor Rated Voltage P0.08 (V)
Motor Rated Power Factor P0.09 (cosΦ)
Ensure the drive is not enabled. (Display shows: inh)
Set P4.01 to 1 to load 50 Hz defaults or 2 to load 60 Hz defaults.
Press the settings key to exit the parameter.
MOT.3
LS 80 L T
N°734570 BJ 02 kg 9
IP55
I cl.f
40 °C
S1
V
Hz
-1
kW
cos
Փ
A
min
230
50
1480 0.75
0.8
1.1
8
7
9
6
5