Gana GN-708VN Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für DVR Gana GN-708VN herunter. Gana GN-708VN 19 Seiten. 4ch stand alone dvr with network

Seite drucken

IV. How to use

4. Getting Start

Hard disk installation & connection

◆

Connection DVR and Monitor

◆

Camera connection (maxim 8)

◆

the other equipments connection (mouse, USB Drive, Motion sensor,

◆

Alarm)

Switch code connection

◆

Power on the switch on back panel

◆

Start to record after confirmation of TV monitoring

◆

Confirm whether hard disk and camera are installed or not.

Hard disk jumper setting should be "master"

After installing hard disk, before roofing case, confirm that DVR recognize

hard disk.

If DVR might be switched off during recording, DVR turn into "Power

Recovery" automatically, then take to rerecord pre-situation.

5. Installation

1) Hard Disk Drive Installation

(A) First, confirm that hard disk's jumper is on "Master".

It must be on Master of hard disk before installing, the

way to set jumper depending on maker's sorts, you

must set after checking hard disk's manual or explain

involved.

(B) Connect hard disk's IDE cable and power on cable

(C)

IV. How to use

2) Monitor connection

Monitor connection is important as you would watch every situation though

monitor. Connect monitor input to MON 1 and MON 2 by cable.

Connect 2 monitor input and

monitor output.

VIDEO IN

Monitor input

3) camera connection

Connect camera input to switch, then connect from CAM1 to CAM4 in order.

Camera input

Video Output

4) Alarm Input

For effectiveness, Every Ground is made to be one.

You can install connect 8 alarm input from 1 to 8.

Ground should be connected with 8 lines and each

input parts should be connected Ground. Each sen-

sor should be power on to power input( depending

on situation) and should be connected to each alarm.

In alarm setting option in menu, you can install in

these 3 modes.(1) Normal-Close (2) Normal-Open

(3) Disable

DVR video output