IKEA FRAMTID HGC2K Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kochfeld IKEA FRAMTID HGC2K herunter. IKEA FRAMTID HGC2K 48 Seiten. Burner

Seite drucken

ENGLISH

Warning! Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of volt-

age.

• Loose and inappropriate plug and socket

connections can make the terminal over-

heat.

• Have the clamping connections correctly in-

stalled.

• Use strain relief clamp on cable.

• Follow the connection diagram.

Important! You must observe the minimum

distances to other appliances and furniture

cabinets or other units according to Assembly

Instruction.

If there is no oven beneath the hob insert a di-

viding panel at a minimum distance of 20 mm

from the bottom of the hob.

Protect the cut surfaces of the worktop against

moisture using a suitable sealant included in

the product in fitting bag. The sealant seals the

appliance to the work top with no gap. Do not

use silicon sealant between the appliance and

the worktop. Avoid installing the appliance

next to doors and under windows as hot cook-

ware may be knocked off the rings when doors

and windows are opened.

Only an authorized service engineer can in-

stall, connect or repair this appliance. Use only

original spare parts.

Only an authorized service engineer can in-

stall, connect or repair this appliance. Use only

original spare parts.

Electrical connection

Before connecting, check that the nominal volt-

age of the appliance stated on the rating

plate, corresponds to the available supply

voltage. Also, check the power rating of the

appliance and ensure that the wire is suitably

sized to suit the appliance power rating (refer

to the Technical data chapter).

The rating plate is located on the lower casing

of the hob.

The appliance is supplied with a connection

cable. This has to be provided with a proper

plug, able to support the load marked on the

identification plate. To connect the plug to the

cable, follow the recommendation given in fol-

lowing figure.

Replacement of the connection cable

The replacement of the connection cable re-

quires the specific equipment of a technician.

In this case, only cable type H05V2V2-F T90

must be used. The cable section must be suit-

able to the voltage and the working temper-

ature. The yellow/green earth wire

approximately 2 cm longer than the brown (or

black) phase wire

The plug has to be fitted in a proper socket. If

connecting the appliance directly to the elec-

tric system, it is necessary that you install a

double pole switch between the appliance

and the electricity supply, with a minimum gap

of 3 mm. between the switch contacts and of a

type suitable for the required load in compli-

ance with the current rules.

The connection cable has to be placed in order

that, in each part, it cannot reach a tempera-

ture 90 °C higher than the room temperature.

The brown (or black) phase cable (fitted in the

terminal block contact marked with "L") must

always be connected to the network phase.

(previous figure).

must be