GREEN LOO KIWI-POD Installations- und Betriebsanleitung für den Eigentümer - Seite 6
Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für den Eigentümer für Toiletten GREEN LOO KIWI-POD herunter. GREEN LOO KIWI-POD 10 Seiten. Dry composting toilet
Seite drucken2. Insert the 65mm vent pipe (supplied) onto the vent outlet of your Kiwi Pod. Cut a hole
in the wall to allow the 65 mm vent pipe to traverse the wall - seal the hole when
finished:
3. Cut off the 65mm pipe on the outside of the wall far enough to allow for the
65mm/100mm T-Junction to attach, slightly away from the wall.
4. Attach your 100mm venting pipe to the wall of the building, including vent cowl. The
vent cowl should be 600mm above where it traverses the roof line.
5. Attach the T-junction as per the picture. Finish with screwing on the cap. This is your
moisture trap, which should be emptied every few weeks by undoing the cap, letting
the water drain out and re-attaching the cap. (you could also drill a small hole in the
cap to let it drain automatically)
6. Allow for a 35mm gap in the 100mm vent pipe where you will insert the fan &
coupling housing. Keep the position of your power supply for this in mind as you
decide where to put the fan:
a. Attach the backing half of the housing at the back of this position
b. Connect the front half of the housing at the hinge side
c. Close the housing
d. Slide the trapezoid shaped fasteners over the top and bottom of the closing
mechanism. Fasten 'hand tight'
6