CeoTronics CT-DECT Base Betriebsanleitung - Seite 11

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Mikrofonanlage CeoTronics CT-DECT Base herunter. CeoTronics CT-DECT Base 14 Seiten. Headset for wireless duplex communication
Auch für CeoTronics CT-DECT Base: Betriebsanleitung (20 seiten), Betriebsanleitung (20 seiten), Betriebsanleitung (14 seiten), Betriebsanleitung (20 seiten)

Seite drucken

If a connection already exists between standard unit 2 and the base unit when standard unit 1 sets up a

connection with the base unit, the connection between standard unit 2 and the base unit is retained and

the base unit switches over automatically to three-party conference mode.

Subsequently duplex communication (speech and simultaneous listening) is possible for the three

parties. In the case of communication sets with PTT button, press the PTT button and keep it pressed

while speaking (see section 2.10).

Connection release

Press one of the three push-buttons in the middle of the push-button bank on the standard unit 1. The

standard unit 1 disconnects itself from the base unit. A high beep tone then sounds in the

communication set of the standard unit 1 and of the base unit. If a connection still exists at this time

between the base unit and standard unit 2, the connection between the base unit and standard unit 2 is

retained. Not until one of the three push-buttons in the middle of the push-button bank on the standard

unit 2 has been pressed does standard unit 2 disconnect itself from the base unit.

4.4

Range warning

If the range limit is reached a high 3-beep P-tone sequence »P-P-P« is audible in the communication

set approx. every 5 seconds. In the case the range limit is crossed the connection will be released. Not

until the base unit and the standard unit(s) have synchronized within the range limit (see section 4.2,

item »a«) the connection can be set up again.

4.5

Battery warning

If the battery has an undervoltage a low 3-beep N-tone sequence »N-N-N« is audible in the

communication set approximately every 10 seconds.

4.6

End of operation

Switch off the unit with the on/off switch and volume control knob (position »

longer usage from the rechargeable battery. If necessary recharge the battery.

Safekeeping – storage

After use, keep the cleaned unit in a clean and dry place at normal room temperature and at normal

relative air humidity.

Recharging batteries

The rechargeable Li-Ion battery 3.6 V/2300 mAh in the unit should only be charged with the charger

supplied with the system. Otherwise the battery may be damaged. The charger is neither water-tight

nor dust-tight. Protect it against water, rain and dirt. The charger may only be used in rooms with

normal relative air humidity and temperature. Do not cover up the charger.

CAUTION

Never use battery chargers to charge non-rechargeable batteries. Never open rechargeable

batteries or throw them into fire. Used (defective) rechargeable batteries are subject to

special waste disposal. Do not put them in the household refuse !

Never charge rechargeable NiCd or NiMH batteries with the charger.

Never charge a rechargeable battery in areas with an explosion risk – an explosion may

result. Charge rechargeable batteries only within a building or similar environment that does

not contain dangerous concentrations of volatile vapors.

Always switch off the unit before you start charging. For charging connect the charger to the multi-

purpose jack located on the bottom of the unit. Notice the special CeoTronics Operating Instructions for

the charger.

«). This guarantees a