CeoTronics CT-DECT Base Betriebsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Sende- und Empfangsgerät CeoTronics CT-DECT Base herunter. CeoTronics CT-DECT Base 14 Seiten. Headset for wireless duplex communication
Auch für CeoTronics CT-DECT Base: Betriebsanleitung (20 seiten), Betriebsanleitung (20 seiten), Betriebsanleitung (14 seiten), Betriebsanleitung (20 seiten)

b. Adjust the flexible swanneck so that the microphone is located at a distance of approx. 5 mm
(0.2 in.) in front your lips. Optimum voice transmission with the best possible noise compensation is
then provided.
4.2

Wearing the headset with an additional head strap

In the event of fast body movements or extreme body postures or if you are using a protection helmet
the headset can be fixed to your head additionally by means of the head strap provided (Fig. 2/a).
a. Pull the headstrap as per Fig. 2 through the slit in the headset muffs and fasten it with the two
retainers (Fig. 2/b).
b. Put on the headset, fold the head band (Fig. 2/c) to the rear and wear the head band as a neck
band. Ensure that the head strap and neck band are tautly seated.
Fig. 2
4.3

Switching on, synchronization, adjusting the speaker volume

a. The rotary knob for switching the headset On/Off and for adjusting the speaker volume is located at
the bottom of the left-hand headset muff. The headset is switched off in position »OFF«. Switch on
the base headset and then the standard headset by means of the On/Off switch and volume control
(rotary knob).
è NOTE
è
The push-button » ) ) « (Fig. 1/d) must not be pressed until the headsets are synchronized
with each other.
Synchronization: A click is audible in the base and in the standard headset roughly 10 seconds
after switching on. The synchronization procedure then begins, i.e. the standard headset seeks its
base headset. This synchronization procedure can last approx. 30 seconds. Upon completion of
synchronization – i.e. the standard headset has found its base headset – a high double-beep tone
sounds in the standard and in the base headset, indicating that the standard and the base headset
are ready for operation. In the case of two standard headsets two high double-beep tones are
audible in the base headset upon successful completion of synchronization.
b. On voice reception adjust the speaker volume for your headset by means of the On/Off switch and
volume control (rotary knob).
è NOTE
è
Always leave the headsets switched on for the usage duration of the headsets so that
immediate operating standby and availability of the headsets are provided.
c. Connection setup and release see sections 4.4...4.4.2.
8