IKEA IHW8305WS0 Installationsanleitung und Gebrauchs- und Pflegeanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Installationsanleitung und Gebrauchs- und Pflegeanleitung für Lüftungshaube IKEA IHW8305WS0 herunter. IKEA IHW8305WS0 28 Seiten. 30"(76.2cm) wall-mount canopy

Seite drucken
1=
f" s cl
Hoo£
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
Using 2 or more people, hang blower housing on the lower
support bracket using the 2 mounting hooks on the rear of
the blower housing•
A. Lower support bracket
B. Mounting hooks
C. Adjust side to side.
D. Adjust up and down.
E. Blower housing
2. Level the blower housing with leveling screws in mounting
hooks, using a level across bottom of blower housing•
3. Remove the metal grease filter and secure the blower
housing with one screw and one washer in the bottom hole
located in the rear of the blower•
•
A
A. Rear of blower housing
B. Bottom 5 x 35 screw hole
Vented Installations Only
1. Fit vent system over transition piece•
2. Seal connection with clamps•
Non-Vented
(recirculating)
Installation
1. Assemble the 3 parts of the deflector with 2 - 3.5 x 9.5 screws
provided• The assembled deflector should be sized to fit the
width of the vent cover bracket installed earlier•
C
B
2=
A. Vent cover bracket width
B• Deflector
C• 3•5 x 9•5 mm screws
Connect the deflector to the vent cover bracket using
4 - 3.5 x 9.5 screws provided.
I
I
I
B
A. Vent cover bracket
B• 3•5 x 9•5 mm screws
3. Measure length of 8" (20.3 cm) vent needed to connect the
transition to the deflector.
NOTE: Vent should fit up inside deflector a minimum of
1" (2.5 cm).
4. Install vent between the transition and the deflector.
5. Seal all connections
with clamps.
8