CEP CT63 Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Touch-Terminals CEP CT63 herunter. CEP CT63 20 Seiten.

3.2 Switching OFF the modem

There are two ways to switch off (power down) the modem as described below:
use the "AT^SMSO" command
EMERG_OFF to high level for t < 1s
A delay of up to 10s is experienced as the modem logs off the network

3.3 Using low power mode of the modem

Below are some short descriptions on how to enter and exit the low power state of the modem.

3.3.1 Enabling the low power mode:

wait until the GSM module is logged onto the GSM network
send the AT command "AT+CFUN=9"
set the RTS control line from High level to Low level
after about 1-2 minutes, a stable low-power mode should be achieved

3.3.2 Disabling the low power mode by user:

Set the RTS control line from Low to High
Low-power mode should be exited automatically
The RS-232 transceiver is activated immediately
AT channel is available again after a short period of time (37ms)
If applicable send AT command "AT+CFUN=1" to remain in normal mode

3.3.3 Disable the low power modes by incoming GSM activity:

The RTS control line is still at a low level
GSM module is called or receives an SMS
Low-power mode is exited automatically
RS-232 transceiver is activated immediately
AT channel is available again after 37ms
If activated by a call the text "ring" is transmitted via the serial interface
The RTS control line on the DB-9 should be set from Low level to High level
AT communication with the GSM module is now available
If applicable send AT command "AT+CFUN =1" to remain in normal mode
15