KitchenAid KICU540BSS Installationsanleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Kochfeld KitchenAid KICU540BSS herunter. KitchenAid KICU540BSS 12 Seiten. Electric induction cooktop

Seite drucken

Locate the junction box to allow as much slack as possible

between the junction box and the cooktop so that the

cooktop can be moved if servicing becomes necessary in the

future.

Do not cut the conduit. The length of conduit provided is for

serviceability of the cooktop.

A UL listed or CSA approved conduit connector must be

provided at each end of the power supply cable (at the

cooktop and at the junction box). A listed conduit connector

is already provided at the cooktop.

Prepare Location

1. Decide on the final location for the cooktop.

NOTE: Countertop must be 1³⁄₁₆" (3.0 cm) to 2" (5.1 cm) thick.

2. If necessary, make cutout in countertop before installing

cooktop. See "Location Requirements" section for more

information.

3. Clean cutout of any remaining dust and debris.

Install Mounting Clips

1. Using 2 or more people, place the cooktop upside down on a

covered surface using the foam end posts from the

packaging.

2. Insert the mounting clips (provided) into the 4 pockets along

the sides of the metallic frame under the glass top.

Insert bottom of mounting clip into bottom of

pocket and rotate top of clipover top of pocket

to snap into place.

INSTALLATION INSTRUCTIONS

If the house has aluminum wiring, follow the procedure

below:

1. Connect a section of solid copper wire to the pigtail

leads.

2. Connect the aluminum wiring to the added section of

copper wire using special connectors and/or tools

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended

procedure. Aluminum/copper connection must conform with

local codes and industry accepted wiring practices.

Install Cooktop

WARNING

Excessive Weight Hazard

Use two or more people to move and install cooktop.

Failure to do so can result in back or other injury.

1. Using 2 or more people, place the cooktop right side up and

insert into cutout.

NOTE: Verify that the front edge of the cooktop is parallel to

the front edge of the countertop. If repositioning is necessary,

remove the cooktop from the cutout completely to avoid

scratching the countertop.