Ganz ZC-DT6312PHAL Gebrauchsanweisung

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Sicherheitskamera Ganz ZC-DT6312PHAL herunter. Ganz ZC-DT6312PHAL 4 Seiten. Colour vandal dome camera

Seite drucken

INSTRUCTION MANUAL

COLOUR VANDAL DOME CAMERA

About this manual

Before installing and using the camera, please read this manual

carefully. Be sure to keep it handy for later reference.

Dimensions : mm

TROUBLESHOOTING

Before sending the camera out for repair, check the items

below. If the problem persists after checking these items,

contact your service center.

■ If no image appears

Is the coaxial cable attached securely?

Are the power and voltage normal?

Has the iris of the lens inside the camera been

adjusted correctly (with the level volume) ?

Is there adequate illumination?

■ If the image is unclear

Is the lens in focus?

Is the lens dirty?

Dirt of fingerprints on the lens can adversely affect the

images. Gently wipe any dirt or fingerprints off the lens

with a soft cloth or lens cleaning paper and cleaning

fluid (commercially available).

Is the monitor adjusted correctly?

WARNING:

TO PREVENT THE RIST OF FIRE OR

ELECTRIC SHOCK, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

PRECAUTIONS

■ Do not open or modify

Do not open the cabinet except during maintenance and

installation, as it may be dangerous and cause damages.

■ Do not put objects inside the unit

Make sure that no metal objects or flammable substances

get inside the camera. It could cause fire, short-circuits or

damages.

■ Be careful when handling the unit

To prevent damage, do not drop the camera or subject

it to strong shock or vibration.

■ Install away from electric or magnetic fields

■ Protect from humidity and dust

■ Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen

or boiler room, as the temperature may raise to high levels.

■ Cleaning

Dirt can be removed from the cabinet only by wiping it

with a soft cloth moistened with a soft detergent solution.

■ Mounting Surface

The mounting surface material must be strong enough to

secure the camera.

CONNECTOR AND CAMERA SETTING

■ CONNECTIONS

DC12V / AC24V

CAUTION :

Check for polarity when using a DC 12V or AC 24V power