KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop Installationsanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Kochfeld KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop herunter. KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop 8 Seiten.

Seite drucken

IH.I

Line Pressure

Testing:

Testing

above l/2 psi (gauge)

The cooktop and its individual shutoff

valve must be disconnected

from the gas supply

piping system during any pressure testing of that

pressures greater than l/2 psig (3.5 kPa).

Testing

at l/2 psi (gauge) or lower

The cooktop must be isolated from the gas

supply piping system by closing its individual

manual shutoff valve during any pressure testing

of the gas supply piping system at test pressures

equal to or less than l/2 psig (3.5 kPa).

Electrical

requirements

Electrical

Shock Hazard

Plug into a grounded

3-prong

outlet.

Do not remove ground

prong.

Do not use an adapter.

Failure to follow

these instructions

can

result in death, fire, or electrical

shock.

If codes permit and a separate

ground

wire is

used, it is recommended

that a qualified

electrician

determine

that the ground

path is

adequate.

Check with a qualified

electrician

if you are

not sure whether

the cooktop

is properly

grounded.

Do Not ground

to a gas pipe.

A 120-volt, 60-Hz, AC only, 15-ampere, fused

electrical supply is required. It is recommended

that a separate circuit serving only this appliance

be provided.

Electronic ignition systems operate within wide

voltage limits, but proper grounding and polarity

is necessary. In addition to checking that the

outlet provides 120-volt power and is correctly

grounded, the outlet must be checked by a

qualified electrician to see if it is wired with

correct polarity.

Recommended

ground

method

For your personal safety, this appliance must be

grounded. This appliance is equipped with a

power supply cord having a 3-prong ground plug.

To minimize possible shock hazard, the cord

must be plugged into a mating 3-prong ground-

type outlet, grounded in accordance with

National Electrical Code, ANSVNFPA 70 -

latest

edition and all local codes and ordinances. See

Figure 1. If a mating outlet is not available, it is

the personal responsibility

and obligation of the

customer to have a properly grounded 3-prong

outlet installed by a qualified electrician.

3-prong

ground-

type outlet

3-pron

groun

plug

,'[I

power

<'I

ground

prong

supply

cord

Figure 1

Now start...

With cooktop

in kitchen.

If installing more than one appliance in the same

cutout, work with one appliance at a time. Start

with the appliance that will be to the left side of

the cutout.

Remove the

shipping materials

I '

and tape from the

cooktop.

Remove the

hardware package from the

side of the carton.

121

Remove cooktop

burner grates and caps

package from shipping

box. Remove pressure regulator

and hardware package from

side of carton.

To avoid scratching

the countertop,

lift entire

cooktop

up from cutout

when repositioning

cooktop

in countertop

opening.

131

Insert the

cooktop into the

countertop

opening. Check that the

front of the cooktop is

parallel to the front edge

of the countertop.

Check

that all required clearances are met. Use a pencil

to mark a line along the rear of the cooktop on

the countertop.

See back cover for wiring

diagram.