Ganz Thermal PT Thermal Series Schnellstart-Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Wärmebildkameras Ganz Thermal PT Thermal Series herunter. Ganz Thermal PT Thermal Series 9 Seiten.

Seite drucken
PT Thermal Series Quick Start Guide
5.
Insert the cable and gland into the camera. Connect the Analog
cable and CAT5 cable to the camera. Slide the gland housing-to-
chassis nut over the cables. Tighten the gland housing-to-chassis
nut into the camera
6.
Not shown, crimp the other end of the cables in place (not
shown).
For All Configurations
1.
Pull the cable(s) taut back through the top hat, exposing the
thread of the cable sealing gland through the bottom of the top
hat.
2.
Assemble the Electrical Nut back onto the gland and tighten the
Nut securely until it is finger tight. Use a flat head screwdriver to
continue turning the electrical nut until it reaches approximately
50 in-lbs of torque.
Wiring & Assembling the PT Thermal Camera
1.
Connect the cable(s) to the respective connector:
a.
Ethernet: Ethernet Port
b.
Analog: Analog Video Out
i.
To ensure a proper fit for RG6 or RG59 coax
cable, loop the excess cable slack along the
bottom of the top hat and then connect the
cable to the Analog Video Out port.
c.
AC/DC Power: Connect wires to power block:
2.
If powering the camera with an AC supply, connect AC+ to the
24VAC input and the AC- to the other 24VAC input
3.
If powering the camera with a DC supply, connect the DC+ to the
12VDC input and the DC- (or ground) to the GND input.
4.
RS-485: Connect wires to RS-485 Block.
a.
5.
Reconnect Power to the existing cable(s).
6.
Check for Solid LED on the Ethernet connector to acknowledge
connectivity to the IP network. The status LED indicators are:
a.
b.
6
www.ganzsecurity.com
December 2013
Connect the RS-485+ pin to the camera's POS and
connect the RS-485- pin to the camera's NEG pin and the
RS-485 Ground to the camera's GND.
Solid Amber for 10MB connection
Solid Green for 100MB connection or Flashing Green for
Activity