IKEA IUD8500BX1 Installationsanleitung Handbuch - Seite 16

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Geschirrspüler IKEA IUD8500BX1 herunter. IKEA IUD8500BX1 26 Seiten.

Panel tem

Using the template provided, attach it to the backside of the

custom panel with tape. Make sure that the center of the template

is aligned with the center of the wooden panel and top of the

template is aligned to the top face of the wooden panel.

NOTE: Do not drill deeper then %" (16 mm) to keep from drilling

through panel. Pilot hole depths given are for 3/4"(19 mm) thick

panel.

Mark 4 pilot holes on the wooden panel using the template

provided. Predrill 4 pilot holes using a 3/32"drill bit. Use tape to

mark the drill bit to gauge hole depth. Drill pilot holes

approximately %" (16 mm) into the custom panel.

Attach the 4 plastic studs to the wooden panel using the 4 short

#10 hex head (5A6")screws provided.

qk holes

Install the custom hardware handle(s) on the front of the wooden

panel inside dotted line.

IMPORTANT: If the handle is attached from the back of the

custom panel, the screw holes should be countersunk

for the

screws heads to be flush with the panel. If the handle is attached

to the front of the custom panel, the screw lengths cannot exceed

the panel thickness.

assembly

Align the studs on the custom wood panel to the keyhole slots on

the door assembly. Ensure that all 4 plastic studs are engaged in

the keyhole slots. Slide wood panel down until the top surface of

the wooden panel is flush with the top of the door.

screws

Open the door and align top edges. Predrill 2 pilot holes using a

3/32" d rill bit. Use tape to mark the drill bit to gauge hole depth. Drill

pilot holes approximately

1_/2"(3.8 cm) into the top corners of the

door using hole in liner as a guide.