Avantco 360CPT40 Benutzerhandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kommerzielle Lebensmittelausrüstung Avantco 360CPT40 herunter. Avantco 360CPT40 10 Seiten. Countertop refrigerated prep rails
Seite drucken
Troubleshooting
Compressor Not Running
Fuse blown or circuit breaker tripped.
Power cord unplugged.
Thermostat set too high.
Cabinet in defrost cycle.
Condensing Units Run For Long Periods of Time
Excessive amount of warm product placed in cabinet.
Dirty condenser coil.
Evaporator coil iced over.
Cabinet Temperature is too Warm
Thermostat set too warm.
Excessive amount of warm product placed in cabinet.
Fuse blown or circuit breaker tripped.
Dirty condenser coil.
Evaporator coil iced over.
Warranty Information
Units in this manual are backed by a 1 year replacement warranty. For warranty inquiries or service, first locate:
•
The model number and cabinet serial number (located on the front of the unit, or inside the door jamb).
•
The bold number on the service plate (located on the front of the unit).
• www.WebstaurantStore.com: Call 717-392-7472. You must have your order number ready when contacting.
• The Restaurant Store: If you purchased this unit from your local store location, please contact your store directly.
www.TheRestaurantStore.com: If you purchased this unit online, call 717-392-7261. You must have your order number ready
when contacting.
This warranty does not apply to, and Avantco is not responsible for, any warranty claims made on products sold or used outside of
the United States.
RESIDENTIAL USERS: Avantco assumes no liability for parts or labor coverage for component failure or other damages resulting
from installation in non-commercial or residential applications.
User Manual
Replace fuse or reset circuit breaker.
Plug in power cord.
Set thermostat to lower temperature.
Wait for defrost cycle to finish.
Allow adequate time for product to cool down.
Clean the condenser coil.
Unplug unit and allow coil to defrost. Make sure
thermostat is not set too cold. Ensure that door
gasket(s) are sealing properly.
Set thermostat to lower temperature.
Allow adequate time for product to cool down.
Replace fuse or reset circuit breaker.
Clean the condenser coil.
Ensure doors are closed when not in use. Avoid
opening doors for long periods of time.
- 9 -