BERNHARDT design Code Modular Unit Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Inneneinrichtung BERNHARDT design Code Modular Unit herunter. BERNHARDT design Code Modular Unit 2 Seiten.

Seite drucken

∞≤√

IMPORTANT NOTES

Failure to install product according to installation instructions will result in loss of warranty. Actual configuration may vary.

When moving Code modular units, lift base and move into position. Never lift unit using wall or drag unit across floor.

Yellow carton contains all hardware required for assembly:

Leveling / Ganging Modular Units

Unpack Code modules and move into the desired location.

(See DIAGRAM 1)

Level the seat front-to-back and side-to-side by adjusting

the height of the glides located on the underside of the

plinth bases, under the seating block. (See DIAGRAM 2)

Turn (rotate) the ganging bracket forks so that they are

perpendicular to the seat. (See DIAGRAM 3)

Align the units so the ganging bracket forks will fit around

the ganging bracket plates.

With a person on each side of the modular grouping, push

the units together. (See DIAGRAM 4)

See the following instructions for securing walls with

mending plate.

Adjustable Glide

Visit Bernhardtdesign.com for additional information.

mending plate

4 machine screws

adjustable glides, ganging bracket fork and ganging bracket plate (pre-installed)

Ganging Bracket Plate

View of Underside

c o d e m o d u l a r u n i t s

top cover plate

Adjustable Glide