Makita 1923H Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita 1923H herunter. Makita 1923H 13 Seiten. Power planer
Auch für Makita 1923H: Gebrauchsanweisung (17 seiten), Gebrauchsanweisung (18 seiten)

Seite drucken

For other countries and areas

A nozzle and joint (optional accessories) are necessary

to connect a Makita vacuum cleaner to your tool. Consult

a Makita catalogue or representative on the nozzle and

joint.

Nozzle assembly (optional accessory)

004895

Use of the special nozzle assembly will minimize chip

scatter, making for a cleaner work area.

The nozzle assembly may be attached after the chip

cover on the tool body is removed. When slipping on the

assembly, fit the pin on it into the rear cover hole. Use the

chip cover screws to fasten it in place.

OPERATION

Planing operation

004897

First, rest the tool front base flat upon the workpiece

surface without the blades making any contact. Switch

on and wait until the blades attain full speed. Then move

the tool gently forward. Apply pressure on the front of tool

at the start of planing, and at the back at the end of

planing. Planing will be easier if you incline the workpiece

in stationary fashion, so that you can plane somewhat

downhill.

The speed and depth of cut determine the kind of finish.

The power planer keeps cutting at a speed that will not

result in jamming by chips. For rough cutting, the depth of

cut can be increased, while for a good finish you should

reduce the depth of cut and advance the tool more

slowly.

1. Screw

2. Nozzle assembly

1. Start

2. End

Shiplapping (Rabbeting)

002580

To make a stepped cut as shown in the figure, use the

edge fence (guide rule).

004898

Draw a cutting line on the workpiece. Insert the edge

fence into the hole in the front of the tool. Align the blade

edge with the cutting line.

Adjust the edge fence until it comes in contact with the

side of the workpiece, then secure it by tightening the

screw.

004899

When planing, move the tool with the edge fence flush

with the side of the workpiece. Otherwise uneven planing

may result.

Maximum shiplapping (rabbeting) depth is 23 mm.

You may wish to add to the length of the fence by

attaching an extra piece of wood. Convenient holes are

provided in the fence for this purpose, and also for

attaching an extension guide (optional accessory).

1. Blade edge

2. Cutting line

1. Edge fence

2. Screw