Makita 1923H Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita 1923H herunter. Makita 1923H 18 Seiten. Power planer
Auch für Makita 1923H: Gebrauchsanweisung (17 seiten), Gebrauchsanweisung (13 seiten)

Seite drucken

NOTE:

When planing, move the tool with the edge fence flush

with the side of the workpiece. Otherwise uneven

planing may result.

Max. shiplapping depth is 23 mm.

Chamfering (Fig. 21, 22 & 23)

To make a cut as shown in Fig. 21, align the ''V''

groove in the front base with the edge of the work-

piece and plane it as shown in the Fig. 23.

Nozzle assembly (optional accessory)

(Fig. 24)

Use of the special nozzle assembly will minimize chip

scatter, making for a cleaner work area.

Install the nozzle asssembly (optional accessory) on

the tool using the screw as shown in Fig. 24.

Sharpening the planer blades

(Fig. 25, 26 & 27)

For standard blades only

Always keep your blades sharp for the best perfor-

mance possible. Use the sharpening holder to

remove nicks and produce a fine edge.

First, loosen the two wing nuts on the holder and

insert the blades (A) and (B), so that they contact the

sides (C) and (D). Then tighten the wing nuts.

Immerse the dressing stone in water for 2 or 3

minutes before sharpening. Hold the holder so that

the blades both contact the dressing stone for simul-

taneous sharpening at the same angle.

Connecting a vacuum cleaner

For European countries and areas (Fig. 28 & 29)

When you wish to perform clean planing operation,

connect a Makita vacuum cleaner to your tool. Install

the nozzle (standard equipment) on the tool using the

screw provided. Then connect a hose of the vacuum

cleaner to the nozzle as shown in Fig. 29.

For other countries and areas

A nozzle and joint (optional accessories) are neces-

sary to connect a Makita vacuum cleaner to your tool.

Consult a Makita catalogue or representative on the

nozzle and joint.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Replacement of carbon brushes

(Fig. 30, 31 & 32)

Replace carbon brushes when they are worn down to

the limit mark. First, remove the rear cover and then

replace the carbon brushes. Both identical carbon

brushes should be replaced at the same time.

To maintain product safety and reliability, repairs,

maintenance or adjustment should be carried out by

Makita Authorized Service Center.