Makita 3620 Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita 3620 herunter. Makita 3620 13 Seiten. Router
Auch für Makita 3620: Gebrauchsanweisung (20 seiten), Gebrauchsanweisung (17 seiten), Gebrauchsanweisung (17 seiten), Gebrauchsanweisung (18 seiten)

Seite drucken

1. Specifications

ASSEMBLY

OPERATION

1. Feed direction

2. Bit revolving direction

3. Workpiece

4. Straight guide

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

carrying out any work on the tool.

Installing or removing the bit

003257

CAUTION:

•

Install the bit securely. Always use only the wrenches provided with the

tool. A loose or overtightened bit can be dangerous.

•

Do not tighten the collet nut without inserting a bit. It can lead to

breakage of the collet cone.

Insert the bit all the way into the collet cone and tighten the collet nut securely

with the two wrenches.

A 6 mm or 1/4" collet cone is also provided as standard equipment besides the

8 mm or 3/8" collet cone that is factory installed on the tool. Use the correct

size collet cone for the bit which you intend to use.

To remove the bit, follow the installation procedure in reverse.

Set the tool base on the workpiece to be cut without the bit making any con-

tact. Then turn the tool on and wait until the bit attains full speed. Lower the

tool body and move the tool forward over the workpiece surface, keeping the

tool base flush and advancing smoothly until the cutting is complete.

When doing edge cutting, the workpiece surface should be on the left side of

the bit in the feed direction.

1. Workpiece

3. View from the top of the tool

001985

NOTE:

•

Moving the tool forward too fast may cause a poor quality of cut, or

damage to the bit or motor. Moving the tool forward too slowly may burn

and mar the cut. The proper feed rate will depend on the bit size, the kind

of workpiece and depth of cut. Before beginning the cut on the actual

workpiece, it is advisable to make a sample cut on a piece of scrap

lumber. This will show exactly how the cut will look as well as enable you

to check dimensions.

•

When using the straight guide, be sure to install it on the right side in the

feed direction. This will help to keep it flush with the side of the

workpiece.

001984

2. Bit revolving direction

4. Feed direction