Makita 4323 Gebrauchsanweisung - Seite 9
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita 4323 herunter. Makita 4323 17 Seiten. Makita 4323 jig saw: specifications
Auch für Makita 4323: Teile-Handbuch (2 seiten), Gebrauchsanweisung (19 seiten)
Seite drucken
1. Starting hole
1
1. Hose
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole
002760
For internal cutouts without a lead-in cut from an edge, pre-drill a starting
hole 12 mm or more in diameter. Insert the blade into this hole to start
your cut.
1
B) Plunge cutting
002761
You need not bore a starting hole or make a lead-in cut if you carefully do
as follows.
(1)
Tilt the tool up on the front edge of the base with the blade point
positioned just above the workpiece surface.
(2)
Apply pressure to the tool so that the front edge of the base will not
move when you switch on the tool and gently lower the back end of
the tool slowly.
(3)
As the blade pierces the workpiece, slowly lower the base of the
tool down onto the workpiece surface.
(4)
Complete the cut in the normal manner.
Finishing edges
002767
To trim edges or make dimensional adjustments, run the blade lightly along
the cut edges.
Metal cutting
Always use a suitable coolant (cutting oil) when cutting metal. Failure to do so
will cause significant blade wear. The underside of the workpiece can be
greased instead of using a coolant.
Dust extraction
002771
Clean cutting operations can be performed by connecting this tool to a Makita
vacuum cleaner. Insert the hose of the vacuum cleaner into the hole at the
rear of the tool. Lower the dust cover before operation.
NOTE:
•
Dust extraction cannot be performed when making bevel cuts.
9