Garage Tek GT8503E Installationsanleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Flutlicht Garage Tek GT8503E herunter. Garage Tek GT8503E 5 Seiten. Security floodlight solar powered

Seite drucken

ONCE YOU HAVE THE SETTINGS WORK UNDER THE CONDITIONS YOU PREFER, TEST THE COVERAGE AREA

OF THE SENSOR BY WALKING AROUND (AT THE LUX SETTING YOU HAVE SET.). YOU CAN ADJUST THE ANGLE

OF THE MOTION SENSOR PIVOT ANGLE AND THE SENSITIVITY SETTING TO OBTAIN DIFFERENT COVERAGE

AREAS.

MAINTENANCE

1. KEEP THE SOLAR PANEL AND LIGHT LENS CLEAN. WIPE WITH A CLOTH AND / OR WITH SOAPY WATER.

2. IF YOU STORE THE UNIT INSIDE FOR MORE THAN 2-3 DAYS, TURN THE SWITCH FROM AUTO

TO OFF .

RECHARGE THE BATTERY AS DESCRIBED IN STEP #2, WHEN PUT BACK IN SERVICE IF STORED FOR

ANY EXTENDED LENGTH OF TIME.

3. THE BULB IS A STANDARD, TWO PRONG, 10 WATT, 6 VOLT, HALOGEN BULB. USE A FLAT BLADED

SCREW DRIVER TO POP OFF THE LENS AND REPLACE AS NEEDED. DO NOT TOUCH THE BULB WITH

YOUR BARE FINGERS. THEY HAVE OIL ON THEM AND THIS OIL CAN CAUSE THE BULB TO BURN OUT.

4. WITH NORMAL USE, THE BATTERY WILL NEED REPLACEMENT AFTER 3 YEARS. A STANDARD 6V, 4Ah,

LEAD ACID RECHARGEABLE BATTERY IS USED. REMOVE THE 4 HOUSING SCREWS ON THE BACK OF

THE UNIT TO ACCESS THE BATTERY FOR REPLACEMENT.

PG 4

GT8503E SECURITY FLOODLIGHT

QUESTIONS ???? CALL 1-866 664 2724

SOLAR POWERED

REV 2, 12/11