CORNING NI-3012 Anweisungen für Kunden - Seite 4

Blättern Sie online oder laden Sie pdf Anweisungen für Kunden für Netzwerk-Hardware CORNING NI-3012 herunter. CORNING NI-3012 4 Seiten. Network interface device

Seite drucken

Upgrade Line Count

To add additional lines, remove the plastic divider and install

modules in next available position as required. Replace remaining

plastic divider segments in any unused positions.

With the module at 45 degrees and mounting feet aligned with

openings in base (Figure 8), press feet into openings and rotate

telco terminal end of the module onto the ground bar tang until

ground clip is fully engaged.

Testing

9.1

Continuity of the Telco Wiring

Step 1:

With the stuffer in the down position, insert test clips into the center of the

test holes on top of the protector in the orientation shown (Figure 9).

Step 2:

Test per standard company practices.

9.2

Continuity of the Subscriber Wiring

Step 1:

Open the line module door by sliding the orange latch to the right. Insert

test clips into the test ports on the subscriber line module in the orientation

shown for each test to check continuity of the entire line module or to

check each line (Figure 10). Move the orange levers to the connected and

disconnected positions to check each individual line.

Step 2:

Test per standard company practices.

Step 3:

Slide the orange module latch all the way to the left and close the module

door.

Corning Optical Communications LLC • PO Box 489 • Hickory, NC 28603-0489 USA

800-743-2675 • FAX: 828-325-5060 • International: +1-828-901-5000 • www.corning.com/opcomm

Corning Optical Communications reserves the right to improve, enhance, and modify the features and specifications of Corning Optical Communications products

without prior notification. A complete listing of the trademarks of Corning Optical Communications is available at www.corning.com/opcomm/trademarks. All other

STANDARD RECOMMENDED PROCEDURE 203-297 | ISSUE 2 | MAy 2015 | PAGE 4 OF 4

Test Telco/Network continuity

from line module to protector with

test clips in this position.

Ground

Bar

Test Subscriber/Customer continuity to

each subscriber line inside the premises

with test clips in this position.

Toggle the orange lever for each

separate line.

KPA-2328

Press Down

KPA-2324

Insert foot of adapter

into opening in NID.

Figure 8k

KPA-2329

Figure 9

Figure 10